I bought a new 9.6V
- A 9.6 volt battery should read around 10 volts or higher after a full charge. If your battery only worked for a minute and has 4 volts then you received a bad battery and it should be returned for a properly functioning battery. Or your battery charger is not charging properly.
- It's simple enough to test. Get a volt meter and set it to DCV (DC Volts). Now turn the charger on as if you were going to charge the battery. Now place the positive terminal in the positive side of the connector on the charger. Do the same with the negative side. If it does not read AT LEAST 9.6 Volts (probably more like 10.2 - 10.5 Volts) then the charger is not putting out enough to charge the battery. A new battery charger will be needed.
- If the volt meter reads anything lower than 9.6 then the battery is bad and you will want to get it exchanged.
- Hope this helps and thank you for using FixYa.
359 views | 1 helpful votes
Speedometer doesnt work but cruise
You need to replace the speed sensor. When replacing the sensor you need not to thread tight. Gently thread till sensor comes to a stop. Back off one half turn then tighten outer flange nut tight. Plug back into harness and secure. Hope this fixes your problem.
341 views | 1 helpful votes
How do you fix the
Good question..I would call them, look at the bottom and find the email or any phone number. To identify the toy, also write down the serial #.And, just then ask them how. I am sure someone there will know..I am sorry I can't be of any more help.
Jada Big Time...
142 views | 0 helpful votes
Not finding what you are looking for?