Jacuzzi Water Heaters - Page 9 - Recent Questions, Troubleshooting & Support

As a reminder always be careful working with gas appliances. https://www.manualslib.com/manual/1075413/Ideal-Logic-Combi-35.html?page=33#manual

www.richmondwaterheaters.com/Contact-Richmond-Water-Heaters

Have you cleaned the air intake screen located below combustion chamber? http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#intellivent http://www.thetankatwaterheaterrescue.com/forums/forum3/ Gene If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Had a similar problem with my boiler. Turned out the blower was bad, was running too fast, and the system was shutting down with an error message. Was expensive to replace.

http://www.fixya.com/support/t25787924-bypass_energy_smart_panel_whirlpool

Request from manufacturer

https://www.youtube.com/watch?v=Uk_htzQKHMQ

Clean the flame sensor

This is not a DIY you need to call for service. this is user non repairable and there is no magic mouse milk 62 i s Maximum Number of Retries Detected 63 is Maximum Number of Ignition Recycles Detected

Google it!

I had the same problem. There's another clear rubber pipe underneath, that runs from the front right to a pump in the middle. I had to pull it off and dry it with a hairdryer before mine would light properly. Blast into the hole the pipe came off too to dry the sensor if there is one.

Check breaker

Go to intertherm website and inquire there

It does that with weak batteries - try replacing with fresh batteries.

here's their site if you can find the model and serial # Hope this helps a little. https://centralboiler.com/support/

Could either be a tripped breaker or the heating element has gone bad.

Call for service, You may have to replace heater. On the bottom is a flame arrester and it may be damaged. They are a one time use.

Go to the manufacturer's website and enter your model number and click on "Support" and there should be a FAQ's, Owners Manual or other support options for you. Otherwise the website may have a "Contact" phone number to call or a way to Chat online.

Search online for "appliance parts" and choose a website for that. You will be asked the model number of the heater and then a list of available parts will come up for you to choose from. I order from RepairClinic.com or APDepot.com and they both often have a video of how to make a repair as well.

it has something to do with ignition ,gas supply, ignitor