Jacuzzi Logo

Jacuzzi Answered Questions & Fixed Issues

Do you work here? Claim your company

  • 376 Products
  • 2K Answers

Should be one on the motor and also check to see if there is a GFCi somewhere too. Could be around where the jacuzzi switch is.

Jacuzzi Home | Answered on Feb 10, 2019 | 63 views

search google

Jacuzzi Home | Answered on Dec 07, 2018 | 95 views

try moving by hand they are calcified

Jacuzzi Home | Answered on Nov 04, 2018 | 79 views

the motor could be seased, can you get to back of motor to see if it's spinning

Jacuzzi Home | Answered on Sep 23, 2018 | 120 views

You have a: Single Stage Jet Pump, c/w Cast Iron Construction, Thermoplastic Impeller, .... coupled to a :
1/2 HP, 115/230 Volt Motor with a 1" x 1-1/4" Discharge x Suction. If you can't find a Jacuzzi, you can always replace it with one of like specs. Check a local plumbing supply dealer or online ...
https://www.grainger.com/category/well-pumps/pumps/ecatalog/N-hve This may also help:

Jacuzzi Pool &... | Answered on Jul 11, 2018 | 86 views

look online using make and model or check manufacturer site for one

Jacuzzi Home | Answered on Jul 10, 2018 | 51 views

either turn on pump or fix recirculation pump

Jacuzzi Home | Answered on May 18, 2018 | 439 views

recirculation pump not working replace

Jacuzzi Home | Answered on May 02, 2018 | 165 views

go into power box inside bottom remove cover see if fuse blown inside if so replace but check heater element for short

Jacuzzi... | Answered on Apr 07, 2018 | 54 views

bad sir switch or relay stuck on

Jacuzzi Home | Answered on Apr 06, 2018 | 61 views

probably the element shorted out and caused the problem
get in an electrician to check the wiring and circuits

Jacuzzi Pool &... | Answered on Mar 24, 2018 | 121 views

This is a bad main board issue

Jacuzzi Pool &... | Answered on Mar 24, 2018 | 1,072 views

Have a look at the leaking jet & decide whether it has a screw thread & a nut fitting in place or if it's bonded to the tub.?
If it's held on by a nut, a new gasket will probably suffice.
If it's bonded on, it will need to be very carefully removed.
The mating faces THOROUGHLY cleaned-up & the exactly right kind of adhesive used, to re-bond the jet onto the tub.
Then it needs to be left to properly dry & cure, before you put any water in it.
Best of luck

Jacuzzi Home | Answered on Mar 15, 2018 | 59 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Jacuzzi Experts

john h

Level 3 Expert

19466 Answers


Level 3 Expert

84540 Answers

ray gallant
ray gallant

Level 3 Expert

61937 Answers

Are you a Jacuzzi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides