Jacuzzi Logo

Jacuzzi Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 376 Products
  • 2K Answers
  • 311K Views

recirculation pump not working replace

Jacuzzi Home | Answered on May 02, 2018


go into power box inside bottom remove cover see if fuse blown inside if so replace but check heater element for short

Jacuzzi... | Answered on Apr 07, 2018


probably the element shorted out and caused the problem
get in an electrician to check the wiring and circuits

Jacuzzi Pool &... | Answered on Mar 24, 2018


Hi,
Have a look at the leaking jet & decide whether it has a screw thread & a nut fitting in place or if it's bonded to the tub.?
If it's held on by a nut, a new gasket will probably suffice.
If it's bonded on, it will need to be very carefully removed.
The mating faces THOROUGHLY cleaned-up & the exactly right kind of adhesive used, to re-bond the jet onto the tub.
Then it needs to be left to properly dry & cure, before you put any water in it.
Best of luck

Jacuzzi Home | Answered on Mar 15, 2018


I had this same problem. I looked at the motor, and on one end (the end opposite where the water comes out) there is a hole in the middle. In that hole is a regular screw tip, which can be used to turn the motor. I filled the tub, inserted a slotted regular screwdriver and turned it about 8 times clockwise, then 8 times counterclockwise. You should see the whole motor turn. Doing this loosened it up, and then it started.

Once it started, all kinds or residue came out, which was probably why it had stopped working. I hadn't used it for a while.

After getting it running I'm going to run some cleaning solution through it, and make sure I run it more often to prevent this in the future.

Jacuzzi EH0 /... | Answered on Mar 04, 2018


possible motor seizure, thermal overload or start/run capacitor problems
call in an electrician for a proper diagnosis

Jacuzzi Home | Answered on Jan 30, 2018


bad motor replace whole pump if grinding its over heating and distorting plastic and seals

Jacuzzi Pool &... | Answered on Jan 20, 2018


possible recirculation pump over heating and turning on and off

Jacuzzi Pool &... | Answered on Jan 20, 2018


LF low flow check recirculation pump and pressure switch

Jacuzzi Pool &... | Answered on Jan 20, 2018


where it stops leaking is where leak is look around fittings

Jacuzzi Pool &... | Answered on Jan 20, 2018


Probably installed incorrectly. The waste line seal has failed.

Jacuzzi Bath Era... | Answered on Dec 28, 2017

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Jacuzzi Experts

john h

Level 3 Expert

19466 Answers

Marvin
Marvin

Level 3 Expert

84540 Answers

ray gallant
ray gallant

Level 3 Expert

61829 Answers

Are you a Jacuzzi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...