PM43c - "Out of Ribbon" error after printing 10-15 labels
Hi,
Honeywell claims that the ribbon should be wound a certain way ("ink out" I believe) in order for this error to go away.
And your ribbon may need to have simple notches within it depending on your setup.
Please review your manual for these features.
Thank you.
How we can get MAC and IP address on Intermec CK30 units?
hi
o obtain the MAC address on a CK3X, CK3R,and 70 Series Handheld computer, follow the steps below:
- Tap the 'Windows' button on the lower left hand corner.
- Scroll towards the bottom of the Windows screen to the "ISpyWiFi" application and tap to launch it.
- ISpyWiFi will open up in the ISpy tab.
- At the top of the screen, look for the 'WiFI NIC' quadrant which displays the MAC address.
11/23/2021 3:57:20 PM •
Intermec...
•
Answered
on Nov 23, 2021
How do you fix a 910 code on intermec cn70 hand held
hi
The newest versions of the firmware are on the intermec website. You will have to register in order to download, but a fake name/address will work...if it is a 740/750 the newest firmware is 4.51 PSM 3.93.1, and if it is a 741/751 the newest firmware is 4.95.1 PSM 4.06. the 760 and 761 have different versions of firmware depending if it is GPRS or CDMA.
11/23/2021 3:54:26 PM •
Intermec...
•
Answered
on Nov 23, 2021
Green light stuck on.
Left the ck30 powered off and removed the battery. Replaced the battery with a fully charged one. After a couple hours rebooted the ck30 and it booted normally. My ck30 was tied to the AS400 system. I think this may have been a factor with this issue.
Windows XP, Active sync 4.5
I don't know much about this but I went through a similar situation yesterday.
Try turning off the scanner, unplug the Router for 30 seconds (and thirty seconds seems like forever) plug the router back in and wait until all the lights come on --don't get in a hurry.
After the lights on the router are all on then turn on your scanner and see if that works.
Hope I haven't wasted your time
Al
3/2/2018 7:41:23 PM •
Intermec CN3
•
Answered
on Mar 02, 2018
Not finding what you are looking for?