Integra Audio Players & Recorders - Recent Questions, Troubleshooting & Support

Help here https://www.google.com/search?q=integra+dtr+5.3+goes+into+protect+mode ..

Hi, Please confirm that the remote has power and move closer to the receiver and attempt to use the remote again. If the remote works when you're closer, then this means that your batteries needed to be updated. If the remote does not work even within 1 foot of the receiver, please clean the section of the receiver that receives the remote signal. You can then restart your receiver and attempt to use the remote again. If this fails, then you can attempt to re-program your remote to the receiver once more. Otherwise, you might need to work with Integra to further troubleshoot the possible source of the issue. Thank you.

http://www.integrahometheater.com/faqs.php Check the connections and try a master reset? Perform a master reset. To do the reset you need to turn the receiver on, then on the front panel of the receiver press and hold the "VCR/DVR" button while doing that press the "STANDBY/ON" button. You will see the word "Clear" in the display screen and the receiver will go into standby mode.

You have a short somewhere in the speaker wiring.

If you have a volt meter you may try and repair it yourself. First however disconnect the speakers and see if the set still goes into protect. If so you may have shorted output and drive transistors. There will be open resistors near them as well. You can compare the bad channel with a nearby working channel since normally only channel shorts out at a time. Always replace outputs in pairs since they in push pull configuration .

They will be value of 10 ohms or less in the secondary power supply attached to the front assembly

if there is smoking near it then it needs to be professionally cleaned