iiyama MASTER - Recent Questions, Troubleshooting & Support

This is due to retrace and can due to higher screen voltage or a fault in the VERTICAL section.Reducing the screen voltage will confirm this and if so there is a failure of a 10-20MFD/250 Volt capacitor.If not a weak capacitor in the vertical section will show the retrace and replacement of the cacpacitor in this section must solve the issue.

My Iiyama Vision Master Pro 450 works with Windows 7 when connected with a VGA video cable that has 5 BNC RGB connectors that attach to the back of the Iiyama monitor. No driver install was needed; Windows 7 shows my Iiyama monitor as a "Generic Non-PnP Monitor" with 1024x768 resolution.

What's the question? There's no real need to go above 85Hz, I think in nvindia you have to go to an advance menu and you can force an output, google it.

Hi: For me it seams that the problem is on the graphic board that doesn't have enought energy to send information to the monitor. I sugest that you try another graphic board or another monitor on the same graphic board. ;) Regards

Try downloading and installing drivers.

I found some here:

http://www.howtodrivers.com/model38655.html

These were a fine monitor and with the kind of image quality you cannot get on TFT's.
If you know the graphics card you are using is working ok, have checked the VGA cable connection and socket at the monitor and computer and have tested the monitor on another computer, that would rule out any problems as far as connected devices are concerned.

The problem you describe, and it is unusual that it has happened so quickly, points to a failure of the monitor internal board. You may be able to get this repaired at a reasonable cost by seeking the opinion of a TV repairman, who might be able to fix it.

there is the problem with ur mother monitor mother board i.e. solders get moistures u have to re soldering the all the components of ur monitor mother board.
best solution is the, go to the nearest electronics repairing shop near by u.

your pitcher in moniter is going bad replace moniter.

Get a new tv.

If you want a Iiyama driver go to the Iiyama website, follow links for support and downloads.

If you want a Relisys driver, go to the Relisys website and follow links for support and downloads.

you may download it from "http://www.howtodrivers.com/model579296.html"

if you get a video camera & wave it from left to right while pointing it at the screen you'll just see the image in the flicker