Hyundai Televison & Video - Page 6 - Popular Questions, Answers, Tips & Manuals

first thing is the obvious, make sure you have brand new batteries installed. If you have a camcorder or digital camera, point it at the remote control and push record, while recording, press some of the buttons on the remote. the camera will record the red light if the remote is working (camcorders and digital cameras can see this light even though people can't) to do this with your digital camera, have somene push and hold one of the remote control buttons while you take a photo, the red ligth should show up in the photo. If you see no red light then you have a bad remote control and will need to send for one or get one ordered through the store, one other option is to buy a universal remote control and try getting that to work, good luck

thegoi_16

I can provide you with instructions and codes for DISH Network equipment. I have provided a link with this information. If you have DISH Network equipment, select your receiver model and follow the instructions. At the bottom of the page are links for your receiver model with the TV codes for programming the remote. I hope this helps.

http://www.dishnetwork.com/SupportSection/remote-setup
Ray Calo
DISH Network

explain a little more detail is there just no power when plugged in

If this set is under warranty you should return it to get it repaired/replaced by the seller. IF YOU KNOW HOW TO WORK WITH ELECTRONICS REPAIR(board replacement) or have a friend with knowledge/skill you can fix it. With the set on place a bright flashlight again the screen. Look for a moving image around the edge of the flashlight. This will show an image is getting to the screen. You just need a back light to see it. The back light inverter board needs to be replaced. This is the board that controls power to the fluorescent lamps that light the screen. Since you did not give a make and model of the set I can not give more information.

Your best bet is likely to be Amazon.
If you can't find the specific one for your player they do sell a variety of 'universal' in car chargers for all sorts of electronic devices with a selection of inter-changeable end connectors to suit your equipment.
The charger socket on your player should have a symbol on it to indicate polarity (whether the pin or sleeve is positive or negative) it should also show the correct voltage required - check that any charger you buy covers that voltage range.

dear user,

kindly off the unit bcoz supply capacitor are leaking oil, and that will bring short circut to your lccd..
kindly change the main capactior before happening this..and must cleaned the oil from supply board

Try website like Remotes.com to buy an original remote.

If you were to log on to the manufacturer's web site, I think you will be pleasantly surprised as usually one is able to download if available, by model number, Customer Instruction Manuals, list of Dealers, for spare parts and service, Driver downloads and Installation Instructions as required.

This is the best way of ensuring up to date drivers for your system and they are free of charge!

I hope this helps.

the source, future shop, dollar store, londen drugs, wall Mart all have universal remotes, and will likely have one that will work with your brand of TV

Hello,

To hard reset your television, all you have to do is power it off and unplug the television for a while, then plug it and power it on. That should do the job or you hold down the power button for about 15 to 20 seconds then the television will restart by itself.

The problem is from the connection, first check if the prongs connecting the cable to the television are properly connected, then you check if the cable is on.

It is only when the television does not recognize any cable or signal it displays the 'no signal' message. So secure the connection and the television will pick the signal.

Take care

Power supply module will be the first place to check, but please read my guides to get some understanding how LCD TV works first.
If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on: Basic LCD monitor and TV troubleshooting guide: http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting http://www.fixya.com/support/r7406380-tv_training_manuals Failed TV and Monitors: http://s807.photobucket.com/albums/yy352/budm Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague Parts: www.shopjimmy.com Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps. Or www.digikey.com, just make sure to use caps with low ESR, 105c, high ripple current and long life rating such as PANASONIC FM or FC series. Please post back what you find. Please leave rating if it helps

I need to know the manufacturer/model of the TV or DVR first.

tengo un problema tengo un tv DAEWOO funciona normal en ecuador pero al mudarme a BOLIVIA la se?al digital desapareci? y vi que en otras tvs iguales al mio entra alguien me podr?a ayudar gracias

This is due to condensation on the circuits. Play music is less demanding than dvd. After playing cd for a long while, you may be able to play one dvd, then several in succession later.

That is because the tv looks for sync alongside composite video from the tuner, then the AV input and then the type of input and all this takes its brain a little while.
Hope that answers your question.

You will find the same with most budget models.
They are probably OK, I don't know.
If you are worried, buy a well known Sony or Hitachi etc.
Hope that helps.

Uno para todos los c?digos alejados de URC 7781 para Hyundai: 0037, 0865, 0556, 0706, 0860, 0753, 0698.1376

Hi bob,
Welcome to FixYa.
My name is John. I will be assisting you with your issue.
You can get it here. www.remotecentral.com
Thanks for choosing FixYa. Happy Holidays........John

You have to go into the menu and go to sound set up and turn the internal speakers on. If that don't fix the audio problem, it is possible the audio processor is locked up. To fix that problem you need to unplug the TV from the wall for 40 MIN, and that will reset the processor back to normal.

from your dvd,plug the yellow to video output red and white to audio output. then plug the other end of the yellow to video input on tv and the red and white to audio input on tv. from tv, plug the other rca cable yellow to video output and red/white to audio output and the the other end yellow to dvd recorder video input and the ed and white to audio input