Hyundai Audio Players & Recorders - Page 6 - Recent Questions, Troubleshooting & Support

0answers
0helpful
1answer

How do I replace rear wheel speed sensor?

when the ESC light come on your car goes into LIMP MODE and wont let it accelerate ,to change the abs sensor you have to remove the wheel you will find a wire on the back of the hube that goes up to the frame take the bolt out and unplug it on the frome side (can sometimes take a lot to wiggle it out of the hub)
6/2/2014 10:12:36 PM • Hyundai 2008... • Answered on Jun 02, 2014
0answers

P200 code

Be the first to answer 5/9/2014 7:35:28 AM • Hyundai 2011... • Posted on May 09, 2014Be the first to answer
0helpful
1answer

I have santa fe 2009 ,esp +4wd lamps in the dashboard are blinking.what the reason

Hello Thanks for using Fixya. It sounds like a bad wheel speed sensor. There should be a code set for this which will also give you a wheel location. Hope this helps. Tracer
5/4/2014 12:14:03 AM • Hyundai 2009... • Answered on May 04, 2014
0helpful
1answer

Battery (electrical system warning light) lights

The vehicles charging system has failed. The alternator is at fault
5/3/2014 11:51:59 PM • Hyundai 2009... • Answered on May 03, 2014
0helpful
3answers

Diagnostic obd2 code p0308

Cylinder #8 misfire
4/28/2014 2:15:14 PM • Hyundai Audio... • Answered on Apr 28, 2014
0helpful
1answer

2009 Santa FE GLS - wiper blades will not home.

Move to the desert , Temecula is nice. Seriously, any dealer will adjust the wipers,= probably while you wait.
3/18/2014 5:25:52 PM • Hyundai 2009... • Answered on Mar 18, 2014
0answers

P0106

Be the first to answer 2/4/2014 8:46:25 AM • Hyundai 2012... • Posted on Feb 04, 2014Be the first to answer
0helpful
1answer

Wife's diability require raising passenger seat 2 inches

Remove one seat bolt. Get a replacement bolt 2 inches longer at any hardware store. Spacers can be made with a stack of nuts slightly larger that the threads of the bolt.
1/28/2014 11:06:37 PM • Hyundai 2012... • Answered on Jan 28, 2014
0answers
0helpful
1answer

Brief squeak noise at cold start up

Sounds like a slipping belt. I had a Dodge Ram with a cummins engine that would squeak when turned off it was the surpatine belt that making the squeak as the engine stopped the fan was still moving a touch. Should be nothing to worry about but check the belt for wear and glazing. Change it if need be.
1/11/2014 8:35:14 AM • Hyundai 2012... • Answered on Jan 11, 2014
0answers
0helpful
1answer

Can a rear end collision cause the fuel gague to start acting up.

Yes probably. the level sensor/lever may be jammed up against the side of the tank or lodged in one position ?
12/23/2013 6:26:44 PM • Hyundai 2008... • Answered on Dec 23, 2013
0answers

Gas gauge fuse

Be the first to answer 12/10/2013 7:39:21 PM • Hyundai 2009... • Posted on Dec 10, 2013Be the first to answer
0helpful
1answer

The battery was dead on our 2009 Hyndai Veracruz. It could have been dead for as long as 6 days. We were out of town. Now the battery is charged (lights on and bright), but the car still won't start.

First check Meghan - Try another battery. The power required to make your lights bright is minuscule compared to the cranking voltage necessary to start the engine. You MAY need a new battery. If you are going to leave the vehicle for a period of time, disconnect the battery terminals and re attach when you return.
12/7/2013 1:27:56 AM • Hyundai 2009... • Answered on Dec 07, 2013
Not finding what you are looking for?
Hyundai Logo

182 questions posted

Ask a Question

Usually answered in minutes!

Top Hyundai Audio Players & Recorders Experts

Brad Brown

Level 3 Expert

19187 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66932 Answers

Are you a Hyundai Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...