Husqvarna Recent Questions, Troubleshooting Help & Support

That would be an operator not in seat detected. Check seat switch

May need to have the unit checked. Could be something as simple as a clogged muffler, air filter, fuel filter or engine wear or damage.

Sounds like a bad switch to me. The can and do fall apart inside. Springs, sliding contacts and the parts that make the circuit.

Question moved from Cars and Trucks to correct category. I used to ride enduro, mind you, it was 50 years ago. I rode a Huskie 400 Automatic as a tester. Your overheating issue is well know on this bike! https://www.google.com/search?q=husqvarna+enduro+701+overheating ..

Question edited for clarity. There are videos in this link. https://www.google.com/search?q=adjust+the+carburetor+on+a+Husqvarna+525LS+and+Husqvarna+128LDX ..

if your sewing machine does not work at all --your switch could be defective, or you power cord

Question edited for name of maker and '(what it is)'. Question moved from Cars and Trucks. See if the videos help. https://www.google.com/search?q=husqvarna+z254+drive+tension+spring ..

It has a history of issues! https://www.google.com/search?q=Husqvarna+yth22v46+goes+in+reverse+when+using+forward+pedal+and+goes+forward+using+reverse+pedal ..

If brang new, take it back for a warranty repair/replacement.

The answer is here https://www.justanswer.com/small-appliance/8qhl9-sewing-machine-will-not-read-usb-stick-diamond.html https://www.google.com/search?q=Designer+Diamond.+doesn%27t+read+USB ..

10 for 9 bucks!

Viking 6460 Sewing Machine Parts

https://www.sewingpartsonline.com > viking-6460-sewi... Shop our extensive selection of Husqvarna Viking 6460 parts & accessories! Quick delivery. 90-day returns. ... Bobbins (10 Pack), Viking #4114401.

possible drive belt slipping or transmission skipping

willie ,you are not kidding,just not explaining very well.there is no way a bolt from the chain bar could fall into the crank case. If you mean the outer casing of the whole chainsaw ,that is ok all you need to do is remove the outer case as if you were going to fit a new chain and it wll probably fall out if it has gone the other side take the recoil start off and it will then let me know please

Try using the START/STOP button. If that works then the issue is with the foot control.

Try contacting Husqvarna or its distributor to inquire.

I would check the drive belt going to rear end if not that I would check fluid level in transmission.

Raise the foot! Hours of frustration and this fixed the triple beep when trying to wind the bobbin.

It is here https://www.fixya.com/support/t4087955-pressure_foot_high_cannot_lowered Well done on fixing it. You know we have no affiliations to Husqvarna but they may come across it. ..

$15 here http://www.vikingmanuals.com/Viking_Service_Manuals.htm https://www.google.com/search?q=husqvarna+optima+630+service+manual ..

Try here. There may be a part from another model that will fit. https://www.sewingpartsonline.com/? https://www.google.com/search?q=single+hole+throat+or+stitch+plate+for+Husqvarna+600E ..