HP photosmart 5510 is giving error 0xc19a0035
Step 1: Reset the printer
Reset the printer to recover from printer failures.
-
With the printer turned on, disconnect the power cord from the printer.
- Unplug the power cord from the power source.
- Wait 60 seconds.
- Reconnect the power cord to a wall outlet and to the printer.
note:
HP recommends plugging the printer directly into a wall outlet.
If the error message persists, continue to the next step.
Step 2: Remove the ink cartridges, and reset the printer
Remove the ink cartridges and reset the printer.
- Remove the ink cartridges from the printer.
- With the printer turned on, disconnect the power cord from the printer.
- Unplug the power cord from the power source.
- Wait at least 60 seconds.
- Reconnect the power cord to a wall outlet and to the printer.
note:
HP recommends plugging the printer directly into a wall outlet.
- Turn the printer on.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
- If you receive a prompt to print a calibration or alignment page, do so.
If the error message persists, continue to the next step.
Step 3: Service the printer
Service or replace your HP product if the issue persists after completing all the preceding steps.
10/18/2022 12:23:41 PM •
HP Office...
•
67 views • 0 helpful votes
Black Bull 4 gal. 2 HP air compressor manual
Hi,
If you need the manual please call Buffalo tools at 1-888-287-6981 and ask them to email you the manual. This is the fastest way to get it. Buffalo tolls sells products like the air compressor that you've listed so they should have access to the manuals as well.
Thank you.
ReInstalling the Flip Gate in Printer
Hi,
please take apart the pieces around the flip gate and then put them back together with the intent of the flipgate being the "corner stone" of that part of your printer's construction.
You might also use the barter section of craigslist to find a technician that would be willing to repair the printer in exchange for some of your services.
Thank you.
11/4/2022 7:01:35 PM •
HP Office...
•
37 views • 0 helpful votes
Hi i have hp proliant dl380 g6 server, i want to install new operating system but my keyboard external and internal both also not working.
the HP manual covers all this.
and it does not run W10
it runs SERVER OS, only,
what is an internal keyboard, wow, my DL 380 g7 has no such thing
the keyboard only works at the correct USB port
and monitor jack too front, side by side.
the BIOS has its own commands, in the manual
the RAID must be set up first or there is no place to put the OS
I run w2007 server OS, there, and SSD boot driver
and 7 disks array. for data.
the manuals are free at HPE, web site. for sure G7 and older.
it has specific steps, not seen on desktops ever.
Not finding what you are looking for?