Hotpoint Logo

Hotpoint Popular Questions, Answers, Tips & Manuals

Do you work here? Claim your company

  • 532 Products
  • 82K Answers
  • 2M Views
0helpful
1answer

My Hotpoint FSFL 1810G fridge compartment has stopped working

It is not going into a defrost cycle and you have ice build up between freezer supply vent it frig side. It could be a defrost timer, defrost termination switch or defrost heater problem.
1/14/2019 9:10:03 PM • Hotpoint... • 992 views • 0 helpful votes
0helpful
1answer

Why the first orange light and the green light of my hotpoint fridge model FUFL 1018 is on flashing

There is a problem in the system, read the error codes.
3/8/2019 9:09:38 PM • Hotpoint... • 223 views • 0 helpful votes
0helpful
3answers

I have a Hotpoint Gas Dryer DLL1550RALWN The motor will not start?

Best to contact the manufacturer or an appliance repair service. This is a car forum and we wouldn't have knowledge on you gas dryer.
3/28/2019 12:07:23 AM • Hotpoint Dryers • 131 views • 0 helpful votes
0helpful
1answer

Hotpoint experience tumble dryer condenser. Leaks from underneath

replace it can cause a short
12/19/2018 6:27:09 PM • Hotpoint Dryers • 1,704 views • 0 helpful votes
0helpful
1answer

My Hotpoint microwave oven cuts off after 3 mins. The fan wasn’t working so I replaced the fan motor . Now th3 fan is working the microwave still cuts . Please help

There is a chip that controls TOTAL operation of the microwave, sounds like it malfunctioned. It actually sound like the entire board has malfunctioned. good luck https://www.6ya.com/mrmmike
3/2/2019 7:45:35 PM • Hotpoint... • 153 views • 0 helpful votes
0helpful
1answer

Hotpoint washing machine will not turn on with power button and trip switch is fine.

Has it got a "reset"button? If not you could of damaged the circuit board
3/2/2019 3:57:31 PM • Hotpoint Washing... • 148 views • 0 helpful votes
0helpful
1answer

I have a hotpoint stove and the display shows un loc dor and the door is not locked. plus the oven will not work.

Could be in the latch or could be in the control board.
12/11/2018 4:53:55 AM • Hotpoint Kitchen... • 1,374 views • 0 helpful votes
0helpful
1answer

Replacing the door handle on my hotpoint refrigerator door handle model # CTF14CRC

https://www.repairclinic.com/Shop-For-Parts/a4b95c70/Hotpoint-Refrigerator-Handle-Parts there should be a couple of screws to take out one on top and bottom
12/23/2018 6:15:38 AM • Hotpoint... • 631 views • 0 helpful votes
0helpful
1answer

I have a hotpoint refrigerator I changed the water filter but I read there should be a reset button where should it be located?

If there is one it would be on dispenser control.
2/17/2019 1:02:35 AM • Hotpoint... • 134 views • 0 helpful votes
0helpful
2answers

My Hotpoint fridgefreezer is freezing way below the recommended temp what cqn I do??

Inside the fridge is a adjusting knob.
1/26/2019 7:34:29 PM • Hotpoint... • 226 views • 0 helpful votes
0helpful
1answer

Should you replace a 2010 miccrowave hotpoint that smells hot

It depends on the reason for the hot smell - discovering this would mean a trip to the service shop and weighing the cost of that against a replacement microwave. Unless your Hotpoint is something special, it is likely a replacement would make sense. It is wise to periodically measure the power output of a microwave oven by timing the boiling of a measured quantity of water when it is young. When or if the time has extended more than about 10% it is time to think about service or replacement. It is also important to keep the inside of the cabinet clean and all the air vents clear.
3/24/2019 11:33:30 PM • Hotpoint Washing... • 47 views • 0 helpful votes
0helpful
2answers

My hotpoint oven marking is been rubbed off,where can get the stickers.model UT47X

Possibly directly from Hotpoint
11/25/2018 10:46:35 AM • Hotpoint Ovens • 1,126 views • 0 helpful votes
0helpful
1answer

Hotpoint wmfug 942 wash machine f03 error code after minutes into any cycle the first time it happened the machine got really hot

The Hotpoint error code F03-is a temperature sensor fault This could be due to the heating element not coming on.
1/1/2019 9:53:36 PM • Hotpoint Washing... • 321 views • 0 helpful votes
0helpful
2answers

Aquarius hotpoint tcm750 just making a humming noise n not spinning any help

Is it pumping water out?
1/25/2019 9:04:09 AM • Hotpoint Washing... • 168 views • 0 helpful votes
0helpful
1answer

Is it possible for me to get the marking stickers for my oven

Contact manufacturer customer hotline phone# or google search Hotpoint oven UT47X. Marcus
11/25/2018 10:36:19 AM • Hotpoint Ovens • 824 views • 0 helpful votes
0helpful
1answer

I have a hotpoint ffa97 the temperature Is showing 17' on the display panel at the top but the ffz is working OK the alarm is constantly bleeping compressor working and fan in the back is ok?. Help

Check the small fan that blows cold air from the freezer to the refrigerator and replace if it is not working.
12/30/2018 12:55:23 AM • Hotpoint... • 296 views • 0 helpful votes
Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hotpoint Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66835 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39363 Answers

Are you a Hotpoint Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...