Hotpoint Microwave Ovens - Page 5 - Recent Questions, Troubleshooting & Support

0answers
0helpful
1answer

Will not heat

make this test and fix it. God bless you
  1. Check the power diodeThis electronic component is responsible for transmitting current in one direction. If the diode becomes defective it will cause your microwave to not heat. Test the diode and replace it if necessary.
  2. High voltage capacitorResponsible for storing electricity, this part is a key component in any microwave. Remove, discharge, and test the capacitor to determine if it requires replacement.
  3. Damaged magnetronResponsible for generating waves and producing heat. When your microwave is no longer heating properly, replacement will be required.
  4. Thermal CutoffsExamine the thermal cutoffs on both the magnetron and the oven itself. Take off one of the leads and using a volt-ohm meter on RX1, check the terminals. If you get a result other than zero, replace the thermal cutoffs.
11/2/2013 12:39:51 PM • Hotpoint... • Answered on Nov 02, 2013
0helpful
1answer

Blank screen

check for fuses
10/25/2013 10:45:00 AM • Hotpoint... • Answered on Oct 25, 2013
0helpful
1answer

I opened door while oven was heating, and

check the fuses
10/25/2013 10:43:56 AM • Hotpoint RVM1625... • Answered on Oct 25, 2013
0helpful
1answer

Hotpoint rvm1435 won't do anything. help

define anythinng
10/25/2013 10:43:05 AM • Hotpoint RVM1435... • Answered on Oct 25, 2013
0helpful
1answer

Turntable not turning. the plastic piece that

replace the plastic piece
10/25/2013 10:42:32 AM • Hotpoint... • Answered on Oct 25, 2013
0helpful
1answer

Not heating

check if there is an internal fuse attached to the transformer. if there is one and it is nt blown, replace the magnetron.
10/25/2013 10:41:37 AM • Hotpoint... • Answered on Oct 25, 2013
0helpful
1answer

Thermal protector

There can be short in the ribbon connector that connects the control panel to the rest due to some oily deposits. You can try to open it up, remove the ribbon, clean it and put back. It may take a few attempts to align correctly.I am assuming your model is similar to mine.
10/16/2013 8:52:14 PM • Hotpoint... • Answered on Oct 16, 2013
0helpful
1answer

Control panel not working

If you can open up, try to clean the ribbon connector. My oven was sending "1" all the time, filled the memory and caused permanent beeping! I wanted to cut off the "1" connection but after opening I found that the panel was diffuclt to disassemble. I just cleaned the ribbon connector and put it pack. It needed a few attempts to get it to work all the buttons properly. But then it has been working for more than year without problem!
10/16/2013 8:28:00 PM • Hotpoint... • Answered on Oct 16, 2013
0answers
0helpful
1answer

Hotpoint microwave only works a few seconds then

Sounds like its time for a new microwaveYou can probably buy a new one cheaper then fixing the old oneMost controls that display 888 something is shorted out on the controller.Have you tried unplugging it for 5 minutes and plugging back in? I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_54ae41aaaffbab00
8/25/2013 2:39:45 PM • Hotpoint RVM1435... • Answered on Aug 25, 2013
Not finding what you are looking for?
Hotpoint Logo

466 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Microwave Ovens Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66947 Answers

Are you a Hotpoint Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...