Hoover Air Purifiers - Recent Questions, Troubleshooting & Support

I'm afraid you burned a coil in the motor. And accidentally it stopped while that coil is between the contact brushes. Or one of the (or both) brushes are worn.

it may need a clean as there is a air flow sensor, if the flow is not right then it will have this on also a faulty sensor will read this aswell.

It may take a while to cool and reset. If ity has been over an hour the thermal switch could be faulty. Hoover WindTunnel WindTunnel vacuum cleaner Owner Manual Thermal Protector

check for plugged hose from rinse tank and nozzles

Hi! We made the nozzle assembly easily removable for the Max Extract Dual V. Follow these quick steps. Remove both tanks from the cleaner. Lay the cleaner on its back while in the upright position. Lift up rear edge of nozzle. Slide nozzle up and remove from cleaner. I have also attached a copy of the owner's manual which has pictures if you need it. http://hoover.com/file/1088/ Hope this helps!!

Replace the part. This might mean buying a whole new water tank. You can order most parts online. Have your make and model ready. Find a site by google. ie if it's a hoover enter, "hoover parts".

There may be a build up of dust in the machine. Turn it over and remove the screws that hold the beater bar cover and see if there is any white like powder caked on the inlet area.

check main cable & power switch, mAY BE FAULTY

Hey there! The brushes can be removed for cleaning. With the handle in the upright position, tilt the cleaner back so that handle rests on floor. Grab brush assembly and pull firmly. Remove hair and debris from brushes. You may clean the brushes under running water. If for some reason you are not able to clean the brushes, replacement brushes can be ordered by following the link below. Search Results Good luck!

Hey there! The nozzle/valve that releases the solution from the hose may be clogged and not closing off to stop the solution flow. You can try soaking the trigger end in warm water for a few hours to unclog it. Also make sure you are inserting the hose back into the hose slot in the back of the cleaner. If the cleaner is still dispensing from both the hose and the cleaner, your nozzle/valve assembly may need to be replaced. To order a replacement nozzle/valve assembly follow the link below. Search Results Hope this helps!