Honeywell Home Security - Page 3 - Recent Questions, Troubleshooting & Support
When I include any of
*86: On all control panels from 4140-4140XMPT2, Vista-40, and Vista-50, *86 allows a single 4208 to operate as zones 10-17. a. With this field enabled, no other polling loop devices will operate. b. There is a special dip-switch configuration that allows this mode
also: check the loop number of the polling zone is set to 1.
Vista-20p/ps series. when set for ARMED AWAY and
If you arm and do not open the door programed as an entry/exit the system will still think you are inside. So it will only arm your perimeter and not the interior motions. Be prepared for your motions, if any, to set off your alarm if you arm, open door then close it and stay inside.
How to bypass my sensor on a Honeywell alarm sestum
You will need to know which zone the sensor is on. Then enter your USER CODE + BYPASS KEY + two digit zone number. For zone 4 you would use 04. For zone 14, use 14 since it is a 2 digit zone.
The sequence would be USER CODE + 6xx. Wait about 3 seconds for it to respond.
How to open a 2087d Honeywell safe if you lost the battery backup
Honeywell no longer sells the battery back up! I made my own by putting 4 AA Batteries in a series, found a USB cable that matches the plug on the safe door and cut the USB end off the wire. Strip the two wires Red and Black and put the red on the positive side and black on negative side plug it into the safe and put the combo in then turn the handle and open the safe. You can make a battery by going to an electronic store and tell them what you are looking for or if you have a toy at home that has 4 AA batteries you can wire it into that Temporarily open your safe and give the toy back to your kids. LOL
Not finding what you are looking for?