Hitachi SuperScan - Popular Questions, Answers, Tips & Manuals

What is your operating system?

buy a new monitor its a problem with the photon beam

the monitor doesn't need a driver, you are most likely missing display adapter drivers from your computer or can you explain why do you need a driver for your monitor? I've never installed drivers for my monitors in the last 10 years.

Adjust controls on the monitor. There a double box that lays on top of the other. Adjust that option... You may also want to adjust the setting that shows a box with arrows pointing up and down. adjust it as well.. Experiment on the settings. You'll get it right.

hi try to auto-focus your screen, it will be someware in your screen settings, look in your manual

Hi and welcome to FixYa,

Initially, try the lowest possible Screen Resolution in the PC's Display Properties. You could also try lowering the Screen refresh Rates. This is especially so if the PC connects to the TV using composite (yellow) video out or S-Video. In some video cards/settings, it may be necessary to enable twin/dual view in the display properties.

Good luck and Thank you for using FixYa. Happy New Year.

The invalid sync indicates there is no video signal getting to the monitor. Have you checked the connections and video driver card? IF you haven't, you might try a different monitor on the video card to verify that the cabling and card are okay. If both test out as good, the next step would be to remove the cover and check the monitor's connector but that has to be done very carefully with the unit off and given time for voltages to neutralize inside. Even then there might be lethal voltages on capacitors...if you're not experienced, this would be something I'd turn over to someone who is.
Hope this helps.

at the vertical stage of the tv there is a capacitor that is weaken and need to be replaced.

do this by testing all the capacitors on that stage.isolate it and replace it with the same type

1. I turn on the monitor, I hear a 'cracklin' sound
Reply: In a CRT Monitor there is a component called EHT which generates High voltage which is connected to the anode of the CRT, If there is any leakage due to moisture can cause this crackiling sound, You need to clean this high tension wire or replace the EHT ( CAUTION : BE AWARE OF HIGH VOLTAGES )

2. The screen only shows a bright, thin line.
Reply: The vertical Drive section of the monitor is faulty.

Found this,,,,, https://www.justanswer.co.uk/consumer-electronics/c5uh2-hitachi-xl500-won-t-connect-hear-running-no-light.html hope it helps.

You will have to use the HDMI port on the mac. provided you have a HDMI input in the projector

use this? it can backup anything. https://www.2brightsparks.com/download-syncbackfree.html

BENJAMIN, Your message does not qualify as a question or query for a problem, try somewhere else DO NOT MAKE THIS SITE WITH YOUR GARBAGE Take your GARBAGE to another Side Your message qualifies as SPAM

buried in endless spam are you. does it fail on 2nd PC???????????????????????????? but yes, I am the MVP of external HDD< I build my own. Have over 5 here for Backups . lots of causes, for sure bad drive, or missing drivers.. bad HW hardware or BAD software SW. Missing 12vdc 2amp power pack>, lost or using wrong one. when pack above does the HDD spin? usb connected to PC. NO PC stated, NO OS stated, windows/chrome/Linux/android? its at lease 10 years old , see posts back that far. not good old HDD,this old. sold during W7 era. 2009. The drive has 3.5" HDD that needs lots of power (Amps) to start up that big motor inside, and is first thing to learn . 2amps it needs, ok? so if pack is missing it will never startup on any USB port, not rated for 20x standard USB load factors. some laptops only do 0.1amps (100mA) and are useless to startup any hdd motor of any kind. see why here. and see a better extremal solution cheap.! $10 http://www.pcdied.com/external-hdd.html

Tried googling for the answer but couldn't find it. Try calling an it support company, I'm sure they'll help you out for free. Perhaps you can try https://www.computersinthecity.co.uk/, they have been helpful to me in the past.

No. http://www.hitachidigitalmedia.com/en-gb/discontinued-products/plasma-tvs/42-106cm/42pd7200

Hi, What is the router/modem model number? Have you tried a different cable? Have you gone into the menu, networking and setup ?

purchase a Roku box

Maybe this will work for you. https://ibm-hitachi-drive-fitness-test.en.softonic.com/

Try to right click the listing. you should get a dropdown where you can repair of reinstall the drivers