Harley Davidson Lands Phones - Popular Questions, Answers, Tips & Manuals

-Yes. have to be on level surface to be accurate . -Check fluid only in the reservoir. Good luck Mai

Check all of the connections. The frame of the bike is the negative. I would think there is a short somewhere, either inside one of the lamp housings or the wiring harness has chafed and is touching the frame. You will have to check each wire. Check also inside the fuse housing. There may be a wire off or shorting in there.

Go online to the Harley Owners Club for more info. I wouldn't think its much of a job for an experienced mechanic but Harley knowledge is a must. Don't attempt it if you aren't sure. Its a critical item.

online

D08 means over-voltage. You bike is over charging and will cook your battery. You regulator will have to be checked as well as your stator. If you have to drive to a dealership, keep your revs down as low as possible, at least not above 2000 revs. Do not drive more than a few miles or battery may get damaged. The letters simply mean set. So you have D08SEt which means D08 set.

Best to use Harley plugs If the plugs require cleaning between tune-ups, proceed by degreasing the firing end of spark plug using ELECTRICAL CONTACT CLEANER and then dry plug with compressed air. THEN using a thin file flatten the spark plug electrodes because a spark plug with sharp edges on its electrodes requires 25-40% less firing voltage than one with rounded edges. If the plugs cannot be cleaned, replace with them with 6R12 spark plugs. Check the electrode gap with a wire-type feeler gauge and bend the outside of the electrode so only a slight drag on the gauge is felt when passing it between the electrodes. Proper gap measurement is 0.038-0.043 in. (0.97-1.09 mm). Check the condition of the cylinder head and plug threads and if necessary remove deposits by applying penetrating oil and clean them out with a thread chaser. Apply a good sensor safe ANTI-SEIZE to the plugs and then install and tighten them to 12-18 ft-lbs (16.3-24.4 Nm).

size and filtration specs

Points and coils

Did you make sure the shift fork is on proper direction.Soetimes the're offset.These things happen.

https://youtu.be/iASNWfNrjb0

I do not know where it stared from or when

I would need some more description of the sound and like where it is coming from.

left side front and rear lights and the turn signal is not working right side is right where problem.imam Harle Davidson Softail Deluxe in 2006 it was god.na cm 89921-01 A

If you have changed exhaust, air filter even slip ons you likely need a different modules setting or if a carb it needs jetted. My bike always "burped " until I changed over to a S&S, drastic but builder explained that slip ons and K&N changed enough to cause the burp

Hi Firdouse, I just had to do this yesterday:)First you need to login to the Magic Jack account. www.magicjack.comGo to the (Phone Numbers) tabIn the menu, you will see (View-Renew-Add), select that.When the Magic Jack Devices screen shows, you will see a column that says (Device Status).Under that column you will see the date it expires and (Add Years). Select (Add Years).It will then give you the option to renew your subscription for 1-5 years.Thanks, Hope this helps.Please RateGary