Legs hurting a lot
Maybe they've been pushed too far is my guess. I think they might need some rest.
3/28/2014 10:25:44 PM •
Martial Arts
•
1,225 views • 0 helpful votes
Some keys won't work
Try to buy one similar, ( search for one with a display burned ) , and change the keyboard in your Treo.Good luck !
I have a Handspring Visor
If you have hotsynced your Visor with a PC (or Mac), the first time you sync your Visor to that computer, it should restore all the data from the last hotsync to the PDA. This is one big reason that it makes sense to sync your PDA on a regular basis.
Unfortunately, if you never used the hotsync function for your Visor, you may not be able to recover any of your data. This model Handspring Visor requires good batteries or else everything in its memory will randomize and you will lose all stored information. There is a small capacitor in the Visor that provides enough reserve power for about 30-60 seconds when you pull out the batteries. It's for this reason that Palm recommended pulling out only one battery at a time when changing to a fresh set. That minimized the amount of time that the PDA would be without power. That same advice applies equally to Visor PDAs.
Is it possible to retrieve
No once a hard reset is performed all user stored data other than the original factory programming is lost for good.
I have lost my instructions
With the Supertooth switched off, press and hold (for 5 secs) the on/accept button. The lights will flash intermittently.
Then set your mobile phone to search for pairing on Bluetooth. When asked for a code type 0000 (4x zero)
Then the set will be paired.
I have just been given one for christmas and have just done it with my iPhone. Easy as peasy !!
How do u pair supertooth visor go to phone
Put your bluetooth on your phone..
On the supertooth is a green button..press and hold to turn on for around 5 secs and watch for red and blue lights to flash..its pairing mode..now activate phone discoverable. .and pair..enjoy
Is it possible to restore
You will need to do a hard reset as follows:
To perform a hard reset:
1. Hold down the power button on the front panel of the handheld.
2. While holding down the power button, use the reset tool (or
similar object without a sharp tip) to gently press the reset button.
3. Release the power button.
4. When a message appears on the handheld screen warning that you
are about to erase all the data stored on your handheld, do one of
the following:
Press the top scroll button on the front panel of your handheld
to complete the hard reset and display the Digitizer screen.
Press any other button to perform a soft reset.
Note: With a hard reset, the current date and time are retained.
Formats Preferences and other settings are restored to their
factory default settings.
After performing the hard reset the OS will be just as it came out of the box when purchased.
I hope this helps, if so please rate our solution.
Buddy
Corporate Computer
www.ccl-la.com
Turn on the bluetooth
Turn the bluetooth car kit off, by pressing the MFB for some seconds. Now, press and hold the MFB until the blue and red leds blink simultaneously. Then, if your phone's bluetooth radio is off, turn it on, and make it search for other devices (check your phone's user manual for further details). When the Visor Drive is shown, select it to be paired, and if a pairing code is requested, enter '0000'.
Hope it works for you.
Cheers!
Carlos
Not finding what you are looking for?