Haier Washing Machines - Page 8 - Recent Questions, Troubleshooting & Support

Seems peculiar to me there's so much pressure on a drain hose. Are you pumping to a drain much higher than the top of the washer? Just pumping water out of a drain hose shouldn't create much pressure unless the hose is kinked or restricted. Look for that problem first. You could get a hose clamp from an auto parts store that's much more reliable than the spring clamps you're describing. I would try that on the inside and outside connection and see if it solves the problem.

Not much information for DIY repair. It is a portable machine suggest taking it to a repair center and request an estimate for repair. Dead shorts such as this indicates from the successive breaker tripping are usually easy to troubleshoot by a qualified technician and could be an inexpensive repair. It is a very dangerous condition, dead shorts are rare and can present a hazaderous condition for the user!!! Do not attempt any additional use. Hope this helps?

You need to close the machine door, thats what error 1 means :)

Check your belt. It may be shot. And that will cause your machine to do that. The heat will still work but your clothes will not dry.

Hi! On Haier washers error 3 means "Detected washer temperature sensor error" Check connections to washer temperature sensor. Check temperature sensor.

What causes the belts to come off is movement in the bearings, unfortunately in most cases due to the cost of repair it usually means a replacement machine

Detergent goes in the drum with the clothing, fabric softener in the middle of the agitator, the drawer is for delayed start if using soap powder