Haier Recent Questions, Troubleshooting Help & Support

Take it back and get another one. Once you try to work on it, void the warranty.

Just wondering if you found the problem as ours has just started throwing the"E30" code

Normally you need a remote to access the Input Source. All televisions need a remote! If you can access Input, just scroll through them one by one until you get the signal. Replacement remotes are typically $12 to $20. Some Haier as $31. Add your model number after the word 'Haier'. https://www.google.com/search?q=haier+tv+replacement+remote ..

I will tell you that every brand has a different way of removing the front face cover. I sell the Haier Central Heat Pumps and Air Condioners and repair window units. Click Here for the user guide=> HWR10XCA
Most fronts come off after pulling the front cover facing from the top as the bottom is sitting into clips. Most are but you removed a screw fromsomewhere and it just may be only one tha keeps it snug so the cover will remain firm. Here is a link to=> Haier America and thier contact link=> Contact Us and their=> Hot Line

AMERICA & AUSTRALIA U.S.A. & Canada All Haier Products
Hotline : 1-877-337-3639 Please rate my solution after I have helped you resolve the problem and communicate with me. I am offering my help to you free. If need you may contact me here on Fixya or my Forum=> Appliance 911 My contact information is located above the Fixya Ad on my blog here=> Sea Breeze Appliance Parts and Technical Services, www.pcappliancerepair.com
Thanks, Sea Breeze

Hi, it simply means that the humidity level is lower then 35% the lowest setting on the dehumidifier...
It will not run when showing that...

The float switch may be stuck.

There are three things that can cause this. A stuck water inlet valve. Except is hums which means the solenoid is energised. So it is either a switch that tells it to work. Or the control board. Unless you have a multimeter and the ability to check voltages and open circuits, call in a service tech. https://www.google.com/search?q=Haier+fridge+with+water+dispenser+which+won%27t+turn+off ..

check drive belt if ok possible cogs under agitator need to be replaced

Your backlights have failed and need replacing, parts may be hard to find

Turn off circuit breaker and wait for some period . Then turn on check .Have a look on tech https://meethamango.com/

This is a communication error between the indoor and out door units.

Check your whole exhaust line. If it has a buildup in it, it will take longer to cool down, since the air cannot circulate through it.

hi cant help more then this: try the manual in the end of the page see if it helps http://www.haier.com/servicesupport/manualMore.asp if not contact the firm http://contact.haier.com/engdefault.asp if they dont help call a tech guy he'll know whats worng good luck

https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dryer/1-198--/Haier-Dryer-Won-T-Start

it needs a tv repair service tech

Remove the batteries of remote control and press the on/off button for 1 minute facing the remote towards tv set. Then put the batteries back and yesss!! It works ??

SUSPECT THE CONTROL BOARD DIED BUT ONLY A SERVICE TECH CAN TELL YOU FOR SURE AND THEY ARE NOT CHEAP

If resetting the washer doesn’t work, the limit switch may be stuck. The sensor for a unbalanced load is a limit switch. The switch should snap back into standby position when the wash tub comes to a stop. Sometimes the switch will stay stuck. Move the barrel by hand back and forth until it hits the inner walls of washer. It may knock the switch back in place.

Try it with a few clothes placed along the outer walls of the drum. It has a sensor that will try to balance the load before going up to full speed but if there are no clothes or weight in the drum, it won’t start.