Haier Logo

Haier Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 1K Products
  • 26K Answers
  • 678K Views

Thomas,
Most Haier tvs use the same platform or menu for adjusting the settings for the tv picture. This link at bottom is for a different Haier tv but the directions should still work

Haier Televison... | Answered on Oct 07, 2019


Really not enough info to give a good answer yet... was it cooling your home good before you switched to heat? If it wasn't, then most likely your system is low on refrigerant... when it is suppose to be on, check to see that your outdoor unit is coming on, if it is on and the outside unit looks like a block of ice or starting to ice over, the defrost control board has failed and needs replaced.. hope that helps

Haier Heating &... | Answered on Oct 05, 2019


If you are a repairperson the audio board can be found on e-bay to fix it. If you are an owner check the speaker connection on the unit as someone may have misplugged the speaker cable. Also check setup under audio and select internal speakers.

Haier Televison... | Answered on Sep 24, 2019


7 results (0.54 seconds) Search Results

    Haier HDW100WH / HDW100SS - ProductReview.com.au

    www.productreview.com.au > ... > Dishwashers > Freestanding > Haier

    Rating: 1.7 - ‎30 votes
    Haier HDW100WH / HDW100SS: 30 customer reviews on Australia's largest ... 1.7 out of 5 stars for Haier HDW100WH / HDW100SS in Freestanding Dishwashers. ... I putthis review in to do my part for what I think is a great consumer service you ... it it keeps beeping 10 times telling me doors open??and won't begin cycle.

    Haier Dishwasher Error Fault Codes - Lights Flashing ...

    removeandreplace.com/.../haier-dishwasher-error-fault-codes-lights-flash...
    Dec 21, 2015 - Haier dishwasher error codes - flashing lights - beeping ...Dishwasher keep filling water and draining at the same time ... Fix Washing Machine That Won't Drain - Washer Not Draining Water .... 2015; Samsung Galaxy Note 5 Quick Users Guide September 25, 2015; My Freezer Is Cold But The Refrigerator ...

    Dishwasher Has Beeping Sounds Blinking Lights - How To ...

    removeandreplace.com/.../dishwasher-has-beeping-sounds-blinking-light...
    Dec 21, 2015 - At times your dishwasher may need to be reset. ... Haier DishwasherError Fault Codes - Lights Flashing Beeping Sounds My Haier ... Fix WashingMachine That Won't Drain - Washer Not Draining Water .... 2015; Samsung Galaxy Note5 Quick Users Guide September 25, 2015; My Freezer Is Cold But The ...

    How to Troubleshoot & Repair a Dishwasher ' HomeTips

    www.hometips.com/repair-fix/dishwasher.html

Haier... | Answered on Sep 18, 2019


The heating element is located inside the cabinet. There may have been failure of a control element instead of the heater.

Haier Dryers | Answered on Sep 06, 2019


Unlikely. You could wind up turning the A/C on and off whenever you changed channels. Not a good arrangement.

Haier Televison... | Answered on Aug 25, 2019


GOOGLE HAIER ERROR CODES

Haier Washing... | Answered on Aug 21, 2019


This could be anything from a faulty water valve , machine not draining , faulty electronic board , faulty timer unit ...For the machine to continue it must complete its last cycle . Any fault codes showing ?, was it filling , was it draining properly ??, please contact your registered whiteware technician for proper fault diagnosys , cheers .

Haier Washing... | Answered on Aug 08, 2019


I have had the exact problem you are describing.
I found that the bearing at the back of the drum where it spins was wearing out & had some free play in it.
That allowed the drum to drop down maybe a 1/8 to 1/4 inch but it was just enough to where close would catch between the edge of the drum & the box part of the dryer which would leave black smear marks on the close.
Sometimes the dryer would run fine, other times it would make scrunchy or screeching noises which was the bearing.
Try this with your dryer to confirm it is the same problem mine had.
Open the dryer door & place the palm of your hand against the front of the dryer with your fingers dangling over the opening.
Place your fingers against the edge of the drum (where the drum butts up against the front wall of the dryer) a push up firmly as if to raise the front of the drum up.
There should be absolutely no movement from that drum other than spinning in a circular motion.
If it raises up just a tiny bit then drops back down when you release it, then you know the problem is the bearing for the drum.
Let me know if that was it or not.

Haier Dryers | Answered on Jul 31, 2019


One thing you can try is to hold down on the power button and plug the unit in. Hopefully you will hear a "beep". Then you need to unplug it for a minute and plug it back in. This is a known procedure to clear error codes from the control computer on units similar to yours, so it might possibly work. Something else you can do is download and look through the Users Manual for your model, which is at this URL: --> http://www.haier.com/products/product.asp?proID=3705 Hope this helps! ;)

Haier HWF08XC5... | Answered on Jul 24, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Haier Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Tom Chichester

Level 3 Expert

54156 Answers

Brad Brown

Level 3 Expert

18108 Answers

Are you a Haier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...