How to wire remote for a Guardian RV generator 7500
1. Locate the remote wiring harness on the generator. This will be a bundle of wires with a plug on the end. 2. Connect the plug on the end of the remote wiring harness to the receptacle on the generator. 3. Connect the other end of the remote wiring harness to the remote control box. 4. Connect the black wire from the remote control box to the negative terminal on the battery. 5. Connect the red wire from
12/23/2022 9:57:04 AM •
Guardian...
•
49 views • 0 helpful votes
GUARDIAN 40G generator crabks but won't run.
Is on/off switch in "on" position - set choke? fill with gas? Is switch on gas line to carb in "on" position.
If does not start then you either have a spark or fuel delivery issue and you need to trouble shoot the various systems.
Ig as was left in carb last time used, it is possible that the gas jelled and clogged up the carb and now the latter needs cleaning/overhaul.
8/31/2015 8:04:00 PM •
Guardian...
•
308 views • 1 helpful votes
Guardian rv generator troubleshooting. The fuse
Not knowing which model youa re talking about it is tough. Obviously NEVER wrap foil around a fuse ! All I can tell by your post is that power is on the fuel pump all the time now, I would say that you have damaged a control board.
10/1/2013 12:49:56 AM •
Guardian...
•
425 views • 0 helpful votes
Charger not charging and motor runs fine
You need to check the rectifier first to make sure it has AC power on the 2 x AC terminals and 13.8V DC on the DC side, if you have AC and no DC replace the rectifier, if you have no AC check the stator windings
I have a guardian quietpact
This is likely a problem with the voltage regulator or the wiring. If this unit has brushes/sliprings for field excitation check the condition of those.
Not finding what you are looking for?