Guardian Electrical Supplies - Popular Questions, Answers, Tips & Manuals
How to wire remote for a Guardian RV generator 7500
1. Locate the remote wiring harness on the generator. This will be a bundle of wires with a plug on the end. 2. Connect the plug on the end of the remote wiring harness to the receptacle on the generator. 3. Connect the other end of the remote wiring harness to the remote control box. 4. Connect the black wire from the remote control box to the negative terminal on the battery. 5. Connect the red wire from
12/23/2022 9:57:04 AM •
Guardian...
•
49 views • 0 helpful votes
GUARDIAN 40G generator crabks but won't run.
Is on/off switch in "on" position - set choke? fill with gas? Is switch on gas line to carb in "on" position.
If does not start then you either have a spark or fuel delivery issue and you need to trouble shoot the various systems.
Ig as was left in carb last time used, it is possible that the gas jelled and clogged up the carb and now the latter needs cleaning/overhaul.
8/31/2015 8:04:00 PM •
Guardian...
•
308 views • 1 helpful votes
Guardian rv generator troubleshooting. The fuse
Not knowing which model youa re talking about it is tough. Obviously NEVER wrap foil around a fuse ! All I can tell by your post is that power is on the fuel pump all the time now, I would say that you have damaged a control board.
10/1/2013 12:49:56 AM •
Guardian...
•
425 views • 0 helpful votes
Charger not charging and motor runs fine
You need to check the rectifier first to make sure it has AC power on the 2 x AC terminals and 13.8V DC on the DC side, if you have AC and no DC replace the rectifier, if you have no AC check the stator windings
I have a guardian quietpact
This is likely a problem with the voltage regulator or the wiring. If this unit has brushes/sliprings for field excitation check the condition of those.
Hello, I installed my 10
I had to find out through a Generac Service Tech that the Idle screw needs to be turned down so it doesnt surge. I found this out after a surge blew $400 worth of electronics out in my home. I have a surge protector now I recommend you do the same. DG
2/25/2011 1:50:12 PM •
Guardian...
•
222 views • 0 helpful votes
I have a generac 50G.
Hello,
This is the easiest way, get a hand held power drill and plug it into one of the 120 volt recepticals. Make sure all the cicut breakers are pushed in before you do this. OK here is the trick, with the generator running, pull the trigger on the drill and spin it hard BACKWARDS. You must keep the trigger pulled and DONT hangonto the chuck after you spin it......... It will just take off spinning. If it doesnt work at first do it again, if it does not work, make sure you are spinning it as fast as you can. If the drill motor does not just take off after three attemps, you might have a bad diode that needs to be replaced.
Hope this works, Let me know :)
Matt If you need further help, I’m available over the phone at
https://www.6ya.com/expert/matt_8dbc24bf722649ac
Not finding what you are looking for?