Great Outdoors Recent Questions, Troubleshooting Help & Support

https://www.manualslib.com/

It sounds like you are getting too much gas and not enough air. There should be an on the gas tube to the burner that slides open to adjust the air/gas mixture. Open this at small amounts unitl the burner burns cleaner (blue,yellow and white)

Hiya, i cannot find the full manual, but if you need, here is there address and tel no that i have copied and pasted from the manual... Hope this is of some use to you .... Cheers Baz... Happy Grilling

CFM Keanall

2695 Meadowvale Blvd
Mississauga, Ontario L5N 8A3

If for any reason we have

failed to meet or exceed your expectations, please allow us the

opportunity to make it right by calling us toll-free during the following

hours:

Monday-Friday 8:00 a.m. - 6:00 p.m., EST.

United States: 1-800-944-8982

Canada: 1-800-668-5323

(It is recommended to avoid calling on Mondays, when wait times may be

prolonged.)

We want you to be completely satisfied with your

purchase so you will agree with our motto,

"there's nothing like...

the great outdoors."™

Turn the LP Gas tank valve off. Disconnect the hose from the tank and wait 5 minutes. Reattach the hose to the tank and turn the tank valve on VERY, VERY SLOWLY (I'm talking slow motion, now). Once the tank valve is completely open, light the burner furthest away from the propane tank and turn it to the highest setting. Continue to light any remaining burners the same way.

If it appears you're still not getting gas to the burners, repeat the above procedure again. If that doesn't solve the problem , you'll need to replace the tank hose and regulator assembly. It can be purchased from any home center. like Lowe's or Home Depot. Just be sure to take your old one with you, to get the proper size.

Hope this gets you up and grilling again.

From the bottom of the leg, up to the center of the roof:
4, 3A, 3, (connector), 1, 1A, 1 (center roof connector)
side support from leg to leg: 2, 2A, 2

try turning the gas nob almost to the off position this worked for me

It sounds like you need a new regualtor.

I had the same problem with mine. I took the burner assembly at the knob apart and cleaned it and that worked for me. The grease from the meat dripped down on the gas orifice and hardened reduced the amount of gas being jetted to the burner. Hope this helps