Gold Medal Kitchen Appliances - Others - Popular Questions, Answers, Tips & Manuals
What was the use date on the Gold Medal flour?
You are probably concerned about the recent Salmonella issue?
The product is the UNBLEACHED all purpose flour:
Gold Medal Unbleached All Purpose 5LB Flour Package UPC: 000-16000-19610-0 Recalled Better if Used by Date: 20APR2020KC
The "use by date" is ink dot printed on each package, usually toward the bottom of the package somewhere.
1/24/2019 6:30:06 PM •
Gold Medal...
•
96 views • 1 helpful votes
Why is it taking a long time to start popping, not popping completely, and leaving excess oil?
Sounds like the kettle isn't getting hot enough. The thermostat is usually at fault in this situation which can be determined by checking the amp draw on the kettle. the common complaint is the kette is too hot and burning but what really is going on is it's not hot enough so the seed won't pop. Because of the heat that is there it will loose it's moisture, dry out and burn instead. You will end up with lots of old maids . Really stale corn seed will act the same way because all the moisture in it is gone and thats what is needed to pop it.
Trying to find kettle wiring drawing 3255
To order a manual from the factory the part# is 67834. Depending on how old this is , those kettles and or similar design had a issue with the nut comming loose that holds down the thermostat thight to the bottom of the pan. The loose nut would then bounce around in there until it touches a elect.connection and ground at the same time. It will short circuit the kettle and end up welding itself in place . so when you turn the kettle on it trips the circuit rite away. you have to dissasemble it and remove it . there is a new locking type nut avalible to replace it.
1/11/2016 10:41:21 PM •
Gold Medal...
•
977 views • 0 helpful votes
My popcorn maker won't spin the kernels. I think it's the stir rod?
There are many possible problems that will cause your agitator to not spin, But you said the gear in the cabinet comes off easily, it should not.
There is a flat part of the motor shaft that extends thru the top of the cabinet that the gear should be tightened onto with an allen wrench via a set screw. This is the first place to check. When the motor is on, you should not be able to stop that cabinet gear from turning. (not easily anyway).
Is there a reset switch after you change filters
If you are speaking about poppers with a Popclean feature, there is not a reset switch. There is a sensor that looks for air movement volume, when the air "vacuum" is weak it sets off the change filter light.
1/25/2015 4:31:15 AM •
Gold Medal...
•
200 views • 0 helpful votes
Kettle motor wont come on and light wont come on
Check that the wall outlet is good by plugging something else into it. Plug the pop corn device into the outlet. Bend the power cord at both ends to see if the unit lights up. If not, you may have a bad connection inside or a bad switch. There also may be a blown fuse inside you could replace.
Why is my gold medal popcorn model # 2552 machine not heating to pop popcorn anymore?
A kettle not heating is either a switch, kettle wires, thermostat, or kettle heater.
Check that the kettle is plugged in tight, notice if the switch lights up when switched, then contact your local gold medal dealer for repairs. It is always cheaper to repair a gold medal kettle than replace.
http://www.gmpopcorn.com/domestic-dealers.cfm
10/1/2014 3:42:57 PM •
Gold Medal...
•
726 views • 0 helpful votes
Not finding what you are looking for?