Refrigerators - Page 5 - Recent Questions, Troubleshooting & Support

Unlikely you have bad boards. Something else is causing the issue. My advice is call in a GE authorised refrigeration tech. Here is the Service Manual if you wish to continue.

GE PSS26MSRBSS Service Manual in PDF format

https://www.allrepairmanuals.com > ... > GE GE Profile Side-by-Side Refrigerator PSS26MSRBSS Service Manual ... Service and repair manuals often refer to the original base model before it was ... Dispenser Features: Child Lock, Dispenser Lig... Approximate Shipping Weight: 380 lb Defrost Type: Frost Guard Filter Location: Upper right corner

possible bad temp sensor or position of it

• 30.0 cu. ft. capacity (Fresh Food 18.15 cu. ft. / Freezer 11.88 cu. ft.)
• Refreshment center
• Electronic monitor / diagnostic system
• Dimensions: 69 3/4 H x 35 3/4 W x 34 1/2 D

The drawer for your freezer is now broken and the hinges are now broken too and they will need to be replaced now.

CALL A LOCAL REPAIR SERVICE IT PROBABLY NEEDS FREON ADDED

If there is a big block of ice in there it will take a little longer than 3 days to defrost because it is well insulated and sealed by the gasket. Aim for 4 to 5.

Condenser Coils are Dirty If the refrigerator is not cold enough the condenser coils may be dirty. The condenser is like a radiator and must stay clean in order to dissipate the heat which was removed from the inside of the refrigerator. As the coils get dirtier the refrigerator becomes less efficient, which makes it work harder to cool down. If the coils are dirty enough, the unit will never be cold enough and will not be able to cool the inside of the refrigerator to the proper temperature. Evaporator Fan Motor If the refrigerator is not cold enough, the evaporator fan motor might have failed. Every refrigerator has a set of coils called an evaporator. The refrigerator may have one or more evaporator fan motor(s) depending on the model and evaporator locations. The evaporator fan motor circulates the cold air from the coils thru the compartment. If there is only one evaporator it is in the freezer side. If the fan is not working, no cold air will get to the refrigerator compartment. The freezer may still get cold. Condenser Fan Motor If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. The condenser fan motor draws air over the condenser coils to cool them. The condenser fan motor is located underneath the refrigerator near the back. Pull the refrigerator out from the wall and remove the access panel to access it. Start Relay If the refrigerator is not cold enough, the start relay may be defective. The start relay is a small device mounted to the side of the compressor. It provides power to the run winding along with the start winding for a split second at start-up to help get the compressor started. If the start relay is defective the compressor may run intermittently or not at all and the refrigerator will not get cold enough. The start relay should be replaced if defective. Temperature Control Thermostat If the refrigerator does not get cold enough the temperature control thermostat might be defective. The thermostat allows power to flow through to the compressor, evaporator fan and condenser fan. If the cooling system fans and compressor are running, but the refrigerator or freezer is not cooling correctly check for an airflow or defrost system problem. Start Capacitor If the refrigerator isn't cold enough the compressor might be having difficulty starting. The start capacitor serves as a battery to give the compressor a little boost during start-up. If the start capacitor is burned out the compressor might not be able to start and run as often as it should. Test the start capacitor first with a capacitance meter, they don't fail often. If it's defective, replace it. Thermistor If the refrigerator is not cold enough the thermistor might be defective. The thermistor is a sensor which monitors the air temperature. It is connected to the control board. If the thermistor is defective the refrigerator does not cool or may cool continuously. Temperature Control Board If the refrigerator is not cold enough the temperature control board might be defective. The temperature control board provides the voltage to the fan motors and compressor. These boards are often misdiagnosed. Check all other components to be certain this is the cause of the problem. Compressor If the refrigerator is not cold enough, the compressor might be defective. The compressor is a motor which compresses the refrigerant and circulates the refrigerant through the evaporator and condenser coils. There are several other components which are more likely to be defective if the compressor doesn't work. If the compressor itself is defective a licensed professional will need to replace it. Main Control Board If the refrigerator is not cold enough the main control board might be defective. This is not common. Check the defrost system, cooling fans, and cooling controls first.

Hello The problem here is your water valve. It does not shut off all the way and allows very slow water flow through the water line. It is so small that it freezes in the supply tube causing a blockage. When your ice maker calls for water the pressure from the blockage pops the line out causing your leak. You need to replace your water valve. Dual valve at the back of the fridge.."water inlet valve")

Most likely happening during defrost. Replace defrost thermostat

Very often you will find the wiring diagram on the back panel, or hidden in the console. There are some here that might be close enough, but not the exact model. https://www.google.com/search?q=wiring+diagram+for+GE+CBC980ST3SS ..

This problem is due to the ice maker water walve not cutting off water supply.. Defective water and ice Solinoid valve defective.

Test and make sure your freezer section is getting to 0° and -5° often times with this problem I find the freezer section just not getting cold enough due to a condenser needing cleaning or condenser fan not working at the right speed Other items to test make sure refrigerator has 4" inch of clearance behind and possibly side but behind is absolutely a must

Question edited for spelling. Question moved from Cars and Trucks to GE Refrigerator. You need a service call to replace the sealing gasket. The whining is probably the fan at the back of the drawer. If the knocking is the compressor, the fridge likely needs a refrigeration gas top up. https://www.google.com/search?q=GE+monogram+refrigerator+climate+control+drawer ..

If it is okay when you go to bed and soaking wet in the morning, your defrost drain is blocked. https://www.google.com/search?q=ge+profile+fridge+defrost+drain ..

yes, dust build-up will cause over-heating and burn-out the defroster circuit-board....you will need to have serviced to see which control board failed for sure. Keep those vents clear....every couple of months vacuum them.Tallon41

The Profile and Artica are good refrigerators. the problem may be the defrost element, defrost thermostat or the mother board. Let me know if you want help on this one. Thanks Sea Breeze

Check the air damper at the back top left of the fresh foods section to see if the damper door has broken and thus not able to close. It is electrically operated, but if it breaks, you can have your exact condition occuer.

Neat calculator here 2.04MOhm https://www.allaboutcircuits.com/tools/resistor-color-code-calculator/ ..

FREEZER FAN MOTOR

There is a fan that blows the cold air down from the freezer to the fridge compartment. It is usually called a freezer fan. Most of them are behind the plastic lining in the freezer. I just noticed that your fridge is a side by side. I have never wored on a side by side but I imagine there is fan in them as well.