GE Grilling - Recent Questions, Troubleshooting & Support

I can provide you with some general instructions on how to wire a 4 burner stove. First, ensure that the stove is disconnected from any power source. Identify the four burners and their respective control knobs. Each burner should have a set of wires connected to it. Remove the control panel cover by unscrewing any screws or bolts that hold it in place. Identify the wiring connections for each burner. The wiring should be color-coded, with one wire usually being black and the other white or red. Disconnect the old wiring connections by unscrewing any screws that hold them in place. Be sure to keep track of which wires go where. Connect the new wiring to the burner by attaching the black wire to the burner's terminal labeled "L1" and the white or red wire to the burner's terminal labeled "L2." Repeat steps 5 and 6 for each burner. Replace the control panel cover and secure it with any screws or bolts. Reconnect the stove to the power source and test each burner to ensure that it is working properly. It's important to note that these are general instructions, and the specific wiring diagram for your GE 4 burner stove may vary depending on the model and year. If you're unsure about the wiring or feel uncomfortable working with electricity, it's always best to consult a professional electrician or appliance repair technician.

Not unusual in my limited experience, we have had two cookers where the ignition system would only light cold burners and would never light all the burners - once the majority was lit there was always a couple that wouldn't light though not always the same two. We never did find the cause...

The plastic cup melted because it was touching the hot plates and not because of the hot oil! It is a poor design but with careful use can be fully functional, plastic is used to keep the cost of this budget product down.