GAS Popular Questions, Answers, Tips & Manuals

Gas lines connect the fuel tank to the carburetor or fuel injection system, while vacuum lines connect various engine components for proper operation. Refer to the manual or a mechanic for specific routing instructions.

Remove Rust- Break down the rust using an acid, like vinegar or a commercial gas tank cleaner, and an agitator, like nuts and bolts. Shake this combination around in the tank throughout the day or longer, depending on the amount of rust and the acid you use. Aug 5, 2021

How to Clean a Motorcycle Gas Tank - Tracy Motorsports

https://www.google.com/search?q=get+rust+out+of+a+motorbike+gas+tank ..

It is possible that the issue with your 2000 Plymouth Neon can be attributed to air in the transmission system. When air gets into the transmission system, it can prevent the clutch from engaging. You may need to have a technician bleed out the air from the system in order to fix the issue. Additionally, you could also check for any loose coolant lines or transmission fluid leaks as these could also contribute to the problem.

The main fuse is probably to blame. This can be in the primary junction box underneath the seat. Also, make sure all the fuses in the fairing, saddlebags, and Tour Pack are working. Also, check all of the wire harnesses and the connections to the batteries twice. The starter motor assembly and potentially the starter relay would be the next thing to investigate if all of those parts are in good working order and the main fuse is functioning properly.

float not properly installed --debris

If your 2002 Chevy Blazer is not starting even after you have installed a new starter and ignition switch, there may be several other issues that could be causing this problem. Here are some troubleshooting steps you can take to determine the cause of the issue:

1. Check the battery: Make sure the battery is fully charged and in good condition. If the battery is weak or dead, the starter may not be receiving enough power to turn over the engine.
2. Check the battery cables: Make sure the battery cables are clean and tight. Loose or corroded cables can prevent the starter from getting the power it needs to start the engine.
3. Check the starter relay: The starter relay is a small electrical component that is responsible for sending power from the battery to the starter motor. If the relay is faulty, it can prevent the starter from getting the power it needs to start the engine.
4. Check the clutch safety switch: If you have a manual transmission, there is a clutch safety switch that prevents the engine from starting unless the clutch pedal is fully depressed. If the switch is faulty, it can prevent the engine from starting even if the starter is working properly.
5. Check the fuel system: If the engine cranks but does not start, it could be an issue with the fuel system. Check the fuel pump, fuel filter, and fuel injectors to make sure they are all functioning properly.

If none of these steps solve the issue, it may be necessary to take the vehicle to a qualified mechanic for further diagnosis and repair.

There could be several reasons why a car shuts off while driving or idling after getting gas. One possible reason is a faulty fuel pump or filter, which can cause a drop in fuel pressure and lead to engine stalling. Another possible reason is a malfunctioning ignition system, which can cause misfires and engine shutdowns. Issues with the car's electrical system or sensors can also cause similar problems. Taking the car to a certified mechanic for a thorough diagnosis and repair is recommended. They can perform tests and inspections to identify the root cause of the issue and provide an appropriate solution.

copy and paste https://www.justanswer.com/chevy/5g0jn-fuel-pump-shut-off-switch-located-1999-s10-pickup.html

tank fuel sure, petcock, , mother? tell what you did from start to leak and what was first step.??? removing something, key off? leaking where, (be exact here ,tell it) is this bike parked a long time for months unused or more>? is the fuel bad.? wild guess, bad gas causes the petcock valve to fail. seen it vast times in 58 years of driven and over 30 motorcycles own. 100cc to 1000c, dirt and street. fixed them all by my self. watch out for cell phone drivers, they will kill us today,.

If it was only the noise I would look at the universal joints, but coming out of gear would indicate an internal transmission problem. Take it to a transmission shop soon before you get stranded on the road.

Hi. this is all i can find so try this link might help you out. https://www.google.com/search?client=avast-a-1&q=2008+ultra+classic+acts+like+it+is+starving+for+gas&oq=2008+ultra+classic+acts+like+it+is+starving+for+gas&aqs=avast..69i57.3955j0j9&ie=UTF-8

You aren't talking about the fuel hose, page 25 of the user manual? https://www.manualslib.com/manual/406874/Hyosung-Gv250.html?page=25#manual Sorry, I don't know this motorbike. Here is a service manual. I couldn't spy what you were talking about or I would mention a page.. https://www.manualslib.com/manual/865104/Hyosung-Aquila-250.html

check float needle valve located inside carb fuel bowl

Depends what it is on, but yes a strip down is a good start. The floats might be sticking and the pipe is the overflow.

Hello. It seems you have a mixture/carburetor problem; may be running too rich. By you 'accelerating' the engine, that compounds the problem. Is your bike carbureted or fuel injected?

No 'year make model' so let's make some wild guesses! Badly sealing float valve in bowl of the carburetor. Bad joint on one of the fuel lines. Split or cracked fuel line Leaking fuel tap. Small rust hole in the bottom seam of the gas tank.

check tank- connections--lines and around injector for damage or loose connections

damaged or blown gasket --damaged manifold

One or more of the carbs is probably flooding due to worn float valves, dirty float valves, damaged floats or maladjustment...

Have you cleaned out the gas tank and made sure it is clean with no water. Have you replaced the Fuel filters. Have you adjusted the carburetor properly. Have you ever replaced the spark coil, it could be bad. Have you made sure the air filter is clean and clear of any obstructions.