Funai Recent Questions, Troubleshooting Help & Support

THat means it is unable to record successfully. Try cleaning the lens with compressed air in a tin, (used for cleaning). Do Not use a cleaning disc, as that can lead to permanent damage to the lens and focus coils.

What is the error message? Have you tried DVD+R discs? Have you ever recorded with this device in the past? What were the events prior to you receiving the error?

I can't find the model of your TV....are you sure you have the right number?

Replace the main board

Bypass for what?

Check for a MUTE button on both the television and the Dish Remote. Or Disconnect both the television and the Dish Decoder for 15 minutes to reset. ..

A lot of time this comes from the source and it's not a fault of the TV

some dvd players (outdated)..will not play these new dvd (recorded or pre-recorded dvd)...if you are recording dvd and wish to play on another dvd player (dvd player must be at least 2009)...same thing happen with my toshiba recorder...my jvc player works its (2008), but my sony dvd (2004) did not play any of the recorded dvds (only the store brought).....suggestion buy a not expensive dvd player (you just need it to play all that other features will push the price range up)

hope this help

On your remote control, press MENU. Highlight Settings with the down arrow button, then push OK. Press OK after highlighting Television with the down arrow button. Select TV resolution, then click OK. Select HD 720p, HD 1080i, or HD 1080p using the arrow buttons. Click OK.

remote https://www.amazon.com/Original-Factory-NC263UH-NB620FX4-NB620FX4F/dp/B07LBT91TV Instructions https://www.manualslib.com/manual/1171015/Funai-Nb500fx4.html#manual

What's the question?

The button (actually a switch) is working correctly. The problem is that the player tray is binding or has a weak motor. The solution is to repair or replace.

038, 046, 223

It’s not the tape, mine is doing it too. Any tech answers?

Try to check the power supply section...most probably dry solder creating issue...check the power button micro switch...check and replace ....

Where dose not firmware find Funai modal 29fl513/94