Frigidaire Washing Machines - Page 8 - Recent Questions, Troubleshooting & Support

Sounds like the brushes to me they are on the motor if worn the motor won’t turn

Sounds like you have a poltergeist. I'm assuming that it's the ghost of Led Zeppelin drummer, John Bonham. I suggest you get in touch with Neil Peart. He can help talk down this restless spirit.

Please tell us what the problem is with your particular washer.

sounds like you need a new timer

Most likely suspension parts related. Maybe a bearing or spider arm.

Check door latch. It may need replacing

Try unplugging for 5 minutes

It is not removeable.

Yes at 22 years old its going to break. Buy new. Tge tub is no longer available for that

Give the drum a spin to see if it's bound up. If no resistance, it could be that the drive belt snapped.

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

It’s connected to drain pump in bottom of machine. You’ll have to determine what has to be removed to access pump.

Frigidaire Affinity Washer Error Code E41 = Control board thinks the door switch is open. Usually replacing the door switch fixes and clears the error code.

waste water outfall pipe blocked or kinked.......... cheers

yes it can, but no one can tell what parts are needed as they are not there to look at it. best solution is to call for service.

If the PAU error does not clear after properly restarting the washing machine cycle, push "Cancel," then disconnect the power cord. Wait a few minutes and restore power to see if the error code goes away. If not, the control board may need to be replaced.

On occasion, the manufacturer will in include paperwork inside of the back. You would have to remove the rear cover or panels.

F8 is a malfunction of the control board. you have to call a repairman to let him replace or fix issue. Good luck.

Any error codes? Drain pump may be blocked.