Electrolux E66 code continuous problem?
Good morning, dissapointed81. I understand that you are experiencing some concerns with your dryer. Before contacting a service provider, I would suggest that you either unplug or turn the circuit breaker off to the unit for five to ten minutes. Let the dryer reset completely and try to use it as normal again. If this does not prove to be effective, we do recommend that a professional technician diagnose the thermal limiter and control board. The E66 error code typically indicates an error within the thermal limiter and interrupted communication to the control board. Though a full repair, and replacement parts, might not be needed we do recommend having a professional test the unit for safety reasons. -Hope this helps!
10/3/2022 6:19:01 PM •
Frigidaire...
•
Answered
on Oct 03, 2022
•
196 views
Frigidaire Model FGUS2642LF1 leaking under the freezer. The appliance tech replaced the freezer door then stated the fridge needed to be defrosted for 24 hrs. My question is why?
All guess work but...
Scenario 1
Your problem was that it need a defrost timer or defrost heater. They are inexpensive parts. He sold you a door as a bonus (for him). Doors only need a new gasket if they don't seal properly. The evaporator at the rear of the freezer is a big lump of ice, and instead of using a heat gun for defrost it, he left you to do it.
Scenario 2
It only need the defrost drain cleaning of gunk and sold you a door as a bonus!
I had Scenario 1, but the local tech was honest. He said I have a defrost timer on the van. He fitted it and said "I can leave you to defrost the ice with a hair dryer and put the back panel back and shelf supports on the freezer, or I can defrost with a heat gun, but it will add 20 minutes to your bill. I go him to finish the job, the cost was minimal.
9/2/2022 5:42:33 PM •
Frigidaire...
•
Answered
on Sep 02, 2022
•
77 views
My Frigidaire up right freezer is showing an error code "FF" and is beeping. What is the issue?
Hey friend, thanks for your inquiry!
Within your Frigidaire freezer the error code "FF" stands for freezer failure. I would perform a reset on your appliance which can be done by either unplugging the power cord or flipping the household circuit breaker. Once the freezer has come back on you should be able to push the "Down" button three times to start it back up.
If that does not correct the issue Please respond back I would like to assist you with any additional information. Hope this helps to some degree. -Matt
8/7/2022 8:10:40 AM •
Frigidaire...
•
Answered
on Aug 07, 2022
•
2,368 views
Not finding what you are looking for?