Frigidaire Refrigerators - Page 4 - Popular Questions, Answers, Tips & Manuals

The filter supplied by the manufacturer.

Automatic defrost systems are better at reducing maintenance costs than fridges with a manual defrost system.

The wiresignal arm is located above the cube bin.

Check the temperture and make the freezer and fridge in the middle setting...wait 24 hours and see if that helps.

CALL YOUR LOCAL REPAIR SERVICE IT NEEDS TESTED WHICH WE CAN NOT DO

English only on Fixya Hi, I need to change the timer on a frigidaire part 134803600, but I don't know how to remove the knob. Any suggestions, thanks. https://translate.google.ca/?sl=en&tl=es&text=Videos%20are%20in%20this%20link&op=translate Videos https://www.google.com/search?q=frigidaire+replace+timer+134803600 ..

neither you or we can add the needed gas so call a repair service

sad to tell you but only a local repair service will be able to figure it out for you

Typically this is a customer alert warning - could be high temperature or open/ajar door or something else. Consult the owner's manual (can often be downloaded from factory website with model) and check the troubleshooting guide near the rear of that manual. With no model number there is no more specific answer.

This has nothing to do with the filter. Just a coincidence. Here is what Frigidaire says: Frigidaire Refrigerator Error Code = 4 Condition = Fridge and the control board goes through cycles but does not detect a damper connection Repair or Check = Check air damper Parts Needed = Air damper

possible low on freon

then call a repair service we just had to buy a new compressor for our 2 yr old AMANA takes special equipment to change them out

Check this site: Frigidaire Refrigerator FGRU19F6QFB Parts List (partselect.ca)

Ur compressor or startn switch is wearing out. The motor n labor can b alotta$. The relay n switch..u cud du urself. Take it off w fridge unpluged..utube can guide u. Then bringit to an appliance or supply for testn. In meantime unplug fridge for awhile n see if symptoms clearup-it will only temporary tho. Also make sure the condensor coils are not dusty..vacuum or wipe..there on back or bottom

Poor defrost water drainage

Check the owners manual, it may only be a high temperature alert that will go away once it cools inside.

https://www.frigidaire.com/Kitchen-Appliances/Freezers/Upright-Freezer/

High Temp Alert If the temperature inside the cabinet exceeds 21°F (-6°C), the LED light at the bottom of the cabinet will flash and the alarm will sound. The alarm can be reset by opening and then closing the door. The LED will continue to flash until the cabinet temperature is below 21°F (-6°C).

Possibly from an appliance parts supplier

beeping is alarm that inside not cold enough

The control arm is a plastic paddle like piece. The usual point of failure is this: https://www.appliancepartspros.com/frigidaire-module-242270102-ap5788338.html

The SH (not 5 H) error indicates that the freezer sensor is shorted in the display. The control can't determine what the freezer temperature currently is. You need to check the wiring between the thermistor (temperature sensor/resistor) and the control board. Replace the thermistor if the wiring has no damage. If the wiring is faulty, replace that. If the fault returns, you may have a problem with the control board. Please add a comment with the model number of the side-by-side refrigerator if you need a parts diagram. I hope this helps. Cindy Wells