Frigidaire Heating & Cooling - Page 5 - Recent Questions, Troubleshooting & Support

unplug it if you can and let it set for 20 minutes, set the temp control where you want it and plug it in, wait a bit and see if it starts cooling. you can confuse these things if you turn it off and on rapidly or change the temp control up and down sporadically. The compressor has to take it's time to kick on after it has been shut off and then on again.

This unit is a 220 volt ac unit. 12-2 wiring is usually for 120 violt circuits?

Amps: 22.2 / 20.0

Watts (Heat): 4900 / 4000

Watts (Cool): 1650 / 1625

Amps (Cool): 7.7 / 8.3

Voltage Rating: 230V / 208V 60Hz

Power Cord Length: 5' (6')

Horsepower (Cool): 2.49

Plug Type: LCDI 6-30P

http://www.frigidaire.com/Home-Comfort/Air-Conditioning/Window-Mounted-AC/FFRH1822R2 hope this helps?

Sounds like a high pressure fault. Is the outdoor fan running? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Sounds as if your blower wheel is damaged or the balance weight has dislodged. Turn power off and inspect blower wheel. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

window units slide into an outside frame section there is a hose attachment area at the back of the ac unit proper that a hose can be attached to and there should be a section in the frame that allows the hose to be fitted to that ac unit proper the unit should be mounted so that it actually slopes slightly down at the rear so water can collect at that drain point there are adaptors that should have come in the packing box for hose attachment if not, many people use white poly piping or electrical conduit with suitable elbows to collect the water at the hole and pipe it back to the wall into a bucket and the collected water used to water plants and gardens

It SHOULD NOT ... (smell in... even in WEST TEXAS). BRAND NEW... Rush on down and get a good NEW one. I would suspect the condensate drip pan is plugged... Common for AC units .. But NEVER in "brand new"... Get that (previously owned (my opinion)) UNIT back from where you bought it ... Trade it in for a CLOSED BOX... and make your sales CLOWN write up why you are returning it. Mold can be quite dangerous!! Carnac the Magnificent

If the blower is not running its likely not setup properly on the tstat. Be sure its setup for electric heat with forced air. Tstat controls the fan If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Sounds like to me that the ac units is drawing too much current for the size of breaker that you, have, check to see if it is on an 15 amp breaker

I have a united minisplit fridigiar 12. 110 volts E6 drive failure. to that is the error.

Can't find E5 but ES is a probable faulty evaporator sensor fault. Check the wireing for any damage or loose conections and if all is ok thenyou will have oreplace the sensor. Hope this helps

Make sure you have power to the unit by plugging something else into the plug

The compressor is being prematurely turned off. That explains why the cooling stops after a few moments. Either the thermostat is responsible or the electronics working with the therm are responsible for the anomaly. Freon level is fine because it does cool when compressor is running. U might also want to check the start/run capacitor. That sucker starts the motor and keeps it running after the start. If the run section goes bad the motor will usually stop after it starts.