Ford Logo

Ford Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 2K Products
  • 627K Answers
  • 8M Views

YOU NEED A TRANSMISSION SERVICE FROM LOCAL SHOP OR DEALER .MIGHT BE LOW ON FLUID THO

2006 Ford... | Answered 1 hour ago


sounds like a fuel delivery problem, have you had the OBD read ?the backfire could be a symptom of timing out or misfire so need to check a few things

2003 Ford... | Answered 2 hours ago


Parking Aid Navigator The parking aid system consists of the following:
  • one radar sensor (located in the center of the rear bumper)
  • two ultrasonic parking aid sensors (located on the left and right side of the rear bumper)
  • parking aid module (located behind the LH C-pillar trim panel)
  • parking aid speaker-audible warning tone (located in the parking aid module)
Expedition The parking aid system consists of the following:
  • four ultrasonic parking aid sensors (located in the rear bumper)
  • parking aid module (located behind the LH C-pillar trim panel)
  • parking aid speaker-audible warning tone (located on the parking aid module)
  • reverse gear select input (to the parking aid module from the reverse lamp circuit)
  • The parking aid system is enabled when the ignition switch is in the RUN position and REVERSE is selected. The system can be disabled through the message center RESET switch located in the instrument cluster. The parking aid menu is displayed until the transmission is taken out of REVERSE. While the menu is displayed, pressing the message center RESET switch changes the parking aid system status to OFF.

Ford Cars &... | Answered 2 hours ago


You need to locate the pipe plug on the center portion of rear axle assembly (it will either be a square protrusion which can be removed with a 5/8 open end wrench or a square depression which can be removed with the square end of a 3/8 ratchet with a short extension). After removing the plug you stick your finger in the hole to the first index & you should feel fluid on the tip of you finger, (or when you remove plug fluid will run out indicating it is full)

Ford Ranger Cars... | Answered 4 hours ago


No the relays are not the same, the cooling fans have relays in the power distribution box. The Blower motor has a "blower motor resistor" near the blower motor.

Ford Cars &... | Answered 4 hours ago


2005 5.4 expedition is 1326548 --standing in front- to your left are 4 plugs designated as 1234 and the right side is 5678,

1998 Ford... | Answered 5 hours ago


P0108 - Barometric Pressure/Manifold Absolute Pressure (BARO/MAP) Sensor High Voltage Detected Description: Sensor operating voltage is greater than 5 volts (VREF). As a result it failed above the maximum allowable calibrated parameter. Possible Causes:
  • VREF shorted to VPWR.
  • MAP signal shorted to VPWR.
  • VREF should be less than 6.0 volts. The PID reading is in frequency/volts.
  • Open circuit.
Diagnostic Aids: VREF should be greater than 4.0 volts.
The PID reading is in frequency/volts. Application Key On Engine Off Key On Engine Running Continuous Memory Vehicles with an EGR system module (ESM) GO to DM1 GO to DM1 GO to DM13 All others GO to DM16 GO to DM16 GO to DM22
Circuit problem .Not sensor .

P0401 - Exhaust Gas Recirculation (EGR) Flow Insufficient Detected Description: The EGR system is monitored during steady state driving conditions while the EGR is commanded on. The test fails when the signal from the differential pressure feedback EGR (DPFEGR) sensor indicates that EGR flow is less than the desired minimum. Possible Causes:
  • Vacuum supply.
  • EGR valve stuck closed.
  • EGR valve leaks vacuum.
  • EGR flow path restricted.
  • EGRVR circuit shorted to PWR.
  • VREF open to DPFEGR sensor.
  • DPFEGR sensor downstream hose is off or plugged.
  • EGRVR circuit open to the PCM.
  • VPWR open to EGRVR solenoid.
  • DPFEGR sensor hoses are both off.
  • DPFEGR sensor hoses are reversed.
  • Damaged EGR orifice tube.
  • Damaged EGRVR solenoid.
Diagnostic Aids: Carry out the key on engine running (KOER) self-test and look for DTC P1408 as an indication of a hard fault. If P1408 is not present, look for contamination, restrictions, leaks, and intermittent faults. Application Key On Engine Off Key On Engine Running Continuous Memory Vehicles with an EGR system module (ESM) - - GO to HH15 All others - - GO to HE36
Clogged catalytic converter ?

Ford Cars &... | Answered 6 hours ago


i have a chipper and it started giving lot of problems 4 yrs ago, so I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

Code-Alarm Code... | Answered 16 hours ago


Don't bother. Go to the company online and tell them to send a new card. If you call and complain sometimes they will overnight it to you for free. They want you to use the credit and spend the money which makes you on the hook for interest payments.

Ford Cars &... | Answered 22 hours ago

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,705 Questions

1998 Ford Explorer
1998 Ford Explorer

2,939 Questions

2001 Ford Focus
2001 Ford Focus

2,580 Questions

1999 Ford Taurus
1999 Ford Taurus

2,315 Questions

2004 Ford F150
2004 Ford F150

2,587 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Brad Brown

Level 3 Expert

17827 Answers

john h

Level 3 Expert

19466 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...