Vacuum hepa gets hot
Carol,
Have you checked to make sure that all of the filters have been cleaned so that you have good air flow? The HEPA filter is your final exhaust filter and if your motor is getting hot because of poor air flow, it will cause the HEPA filter to get hot as well. Hope this helps!
Manuals vax
Check the fuse, replace if blown WITH SAME RATING FUSE. If there has been any damage caused to the cable, have this replaced by A QUALIFIED ELECTRICIAN.
Power head roller brush
go to guarantee vacuum and sewing center tell them the exact model number of the unit and the serial number and the brand tell them what parts you need need and they will be able to get them for you
Need an on/off switch for a Fantom Upright FM741B
Try these:
http://outdates.ecrater.com/http://www.blujay.com/outdatesIf no luck there, any power switch from another 120V product should work as long as the wires match. If you have a normal 2 wire switch, you should be fine. Be sure the amps on the new switch match the old and the terminals are the same size (don't try to force a small terminal onto a large one). Also, be sure that if you use another switch, be sure the terminals are wrapped or protected to keep them from shorting out if they were to fall off. With a little plastic modification, you sure can fit a square switch into a round hole lol. Good luck.
Fantom falcon vac
see you instruction manual or download from www.retrevo.com or www.fitness.manualsonline.com see the diagram. God bless you
Air driven turbo brush
Is this the Lightning model? How old is it? You may have to just replace the belt.Also, the front brush motor will not engage until the power is turned on and the handle is in the down position. In the upright position the brush motor wont engage. Typical faults will be the belt is broken and needs replacing or the fornt brush motor needs replacing.
Not finding what you are looking for?