FAIP Garden - Recent Questions, Troubleshooting & Support

They are all to a general standard like these https://www.google.com/search?q=power+washer+water+inlet+coupler ..

1.Electric Male plug 2.Pressure Hose 3 ON/OFF switch

The water supply may be blocked. Check filters, screens, or it may be air-locked.

I understand it's being sold by SEARS. Ask SEARS' customer service Sears, Roebuck and Company (Compa??a) Atenci?n al cliente: +1 800-697-3277 Asistencia t?cnica: +1 800-469-4663

Hi MikeYou could have one are two problems with the pressure washer.1...pump for pressure washer worn and needs washer/seal replacement.2...Need to adjust the pressure discharge relief valve to the needed pressure.Please take time to rate meBud

To many things to list. i recommend giving our free tech support person ell a call when you can be at the washer and they can walk thru the process of diagnosing it. 1-888-279-9274

Some times the power washer are made poorly. If the leaks are at the hose connection you can replace plastic with a better one made of brass and the use of Teflon tape. Good luck

Are you talking about the electric switch that shuts off the motor when the trigger is released? If so, there is an arm that comes out of the high pressure side of the manifold and is connected to a spring loaded piston. The piston extends under high pressure (spray trigger released) and retracts when spraying. At the opposite end of the arm is an allen screw and locknut. The allen screw bears on the microswitch arm to control the electric motor. When properly adjusted, the motor should turn off when the trigger is released. If it doesn't, loosen the locknut and adjust the allen screw slightly outwards toward the switch. Pull the trigger a few times and verify the motor starts up and shuts down when you release it. Tighten locknut. Hope that helps.