Dodge Logo

Dodge Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 796 Products
  • 329K Answers
  • 5M Views

The more options you have on your car the more fuses it requires, so more locations! Check the trunk (1)next to spare tire, (2) Open door on drivers side and check the panel on side of dash(3) Under hood on drivers side near fender and firewall. Always replace with same size fuse to keep from starting fire ! If you do not have a tester check by rotating good fuse with suspected bad.
Good Luck!

Dodge Cars &... | Answered on Mar 30, 2019


According to Haynes, the V6 engine has the sensor mounted in the bellhousing on the back of the engine.

Dodge Cars &... | Answered on Mar 29, 2019


First look at the master door switch. Make sure that there are no bare wires that are shorting each other. Possible internal switch problem.

Dodge Dakota... | Answered on Mar 29, 2019


Pull the window switch out and check if power is getting to the window in the down position. You could have a bad connection on the switch.

Dodge Office... | Answered on Mar 28, 2019


If you removed the distributor it was put in wrong. Of you moved the distributor it's out of time. If you did not move the distributor or remove the distributor . Recheck the spark plugs and wires they maybe on the cap incorrectly.

Dodge Cars &... | Answered on Mar 28, 2019


hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store
the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

Dodge Cars &... | Answered on Mar 28, 2019


Sometimes there is a bad connection in the ignition switch in combination with the gear shifter. Try wiggling around the two a bit when you turn it to start. But first, can you tell us if there are any bad fuses? Check the fuses.

Dodge Cars &... | Answered on Mar 28, 2019


Do you have any cable plugged into the aux port? If so, remove it and power the radio on/off. Try using the CD if it has one. Did you check the fuse? As a last resort, pull out the radio and disconnect the power lead for a minute and plug it back in. This could reset the unit. Can you provide any more clues?

Dodge Cars &... | Answered on Mar 28, 2019


What year Dodge and what model? Are you experiencing any troubles? Please give us more details.

Dodge Cars &... | Answered on Mar 28, 2019


First start with removing the license plate frame. Then, unscrew the two Torq screws (size: T20?). Wiggle the housing out of the hole and let it hang. Untwist the bulb to replace it. Then, put it back together.

Dodge Cars &... | Answered on Mar 28, 2019


may be a check valve letting warm expanded fuel to slowly leak back to the tank causing hard start. When starting cold its harder to move the cold thick fluid. Check into it. Good luck..

2004 Dodge Ram... | Answered on Mar 27, 2019


To fix a rack leak you need to rebuild the entire unit. This is not a DIY project.

Dodge Cars &... | Answered on Mar 27, 2019


It would be an electyrical problem, mosty likely the lock power actuator is defective

2009 Dodge... | Answered on Mar 27, 2019


The P3497 code means that an MDS solenoid is sluggish to change from turning on or off. The MDS solenoid is one of the 4 solenoids used to switch the engine from 8 cylinders to 4 cylinders. One simple thing that can cause this is using the wrong viscosity engine oil, or low oil. Before doing anything, change the engine oil and filter and use ONLY 5w20 engine oil. Clear the code and drive the truck. If the code returns, then suspect a failing/sticking MDS solenoid and have it replaced. Good luck!

Dodge Cars &... | Answered on Mar 27, 2019


It sounds like you have a leak in your cooling system. take to a shop that puts dye in the cooling line then uses an ultraviolite light to find the leak.

Dodge Cars &... | Answered on Mar 27, 2019


I take help from online websites like reliable-store that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Dodge Cars &... | Answered on Mar 27, 2019


It will be in the engine block close to the timing cover or under the timing cover.....it will have wires coming or plugged into it.....Very Fragile so do not accidently strike....The sensor has a required air gap to aquire a signal......018 air gap should be enough to work........

Dodge Cars &... | Answered on Mar 27, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,240 Questions

1999 Dodge Durango
1999 Dodge Durango

-935 Questions

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

2000 Dodge Durango
2000 Dodge Durango

1,576 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,470 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Brad Brown

Level 3 Expert

18031 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...