How do you loosen and tighten the belt on a 1992 Dodge Dynasty 3.3 engine with ac?
Are you referring to the Auxillary (Fan) belt? These usually have a spring loaded tensioner arm with an idler pulley attached to it. This usually controls the tightness of the belt when the engine is running. They are commonly held on with a single bolt. In most cases if the belt has gone slack this tensioner has failed and will need replacing. You will need to remove the belt before you can do this especially if you want to keep the skin on your knuckles. Yes, I've done that!. It's also worth replacing the belt as well while your in there then you know it's good.
**NOTE** Make a drawing or take photos of the route the belt uses BEFORE you take it off.
2007 Dodge Ram 1500. I have no rear turn signals or brake light. Reverse lights up, trailer wiring works, front works.
Is the trailer wiring new or was it already fitted and the problem has just started happening? Does this problem happen all the time or only when the trailer wires are plugged in? This may sound silly but does the weather affect the problem? For example does it happen after it has been raining and stops when the weather dry up? Have you tested the wiring with a voltmeter/multimeter for actual live voltage?
Using the multimeter on DC volts start at the actual light fitting and work your way backwards. Remove the bulb and test for voltage in the hole the bulb fits into. Next test behind the bulb where the wiring connects to the light fitting. This tests the light fitting itself. Follow the wires back and find where the trailer wiring connects into the wiring harness then check for voltage before and after the connection. This tests for issues between that connection and the trucks rear lights. As you follow the wire look and feel for damage as a small cut or break in the wire can cause big issues.
Check any Ground (earthed) points aren't loose or corroded. If there is still no voltage the next place is the fuse box. A lot ot tail light issues are often in the wiring somewhere near the actual light fittings.
My 2000, dodge durango, will turn over but will not start. I do not think i am getting spark . Please help
It sounds like you may be experiencing an issue with your ignition system. Here are a few steps you can take to troubleshoot:
- Check the spark plugs: Inspect the spark plugs for signs of wear or damage. If they appear worn or fouled, consider replacing them.
- Test the ignition coil: Use a spark tester to check if the ignition coil is producing spark. If there is no spark, the ignition coil may need to be replaced.
- Inspect the ignition wires: Check the ignition wires for any signs of damage or corrosion. Replace any wires that appear damaged.
- Check the distributor cap and rotor: If your vehicle is equipped with a distributor, inspect the distributor cap and rotor for signs of wear or damage. Replace them if necessary.
- Verify fuel delivery: Ensure that your vehicle is receiving fuel by checking the fuel pump and fuel injectors. If fuel delivery is not the issue, focus on diagnosing the ignition system.
If you're unable to identify the problem, it may be best to consult a professional mechanic for further assistance. They will have the tools and expertise to diagnose and repair the issue effectively.
Is there a cabin air filter on a 2001 dodge ram 1500 5.2 thanks in advance.
The 2001 Dodge Ram 1500 5.2 does not come equipped with a factory-installed cabin air filter. As a result, there is no need to locate or replace a cabin air filter in this vehicle model. Keep in mind that newer vehicle models may be equipped with cabin air filters, but for the 2001 Dodge Ram 1500 5.2, it is not a standard feature.
Dodge Journey windows going down by themselves
I have heard of this in fact, In a 2009 Journey R/T. A trip back to your dealer is in fact the best action. The one I know of had multiple electrical issues after the initial window concern within a few months. ie. wipers, signals, radio, heater not working.
Not finding what you are looking for?