No sounds is coming from Channel 2 located in the back of the equalizer
I assume you have already swapped the In and Out cables left-to-right to see if the symptom will follow. Internally, the EQ routes everything through every one of it's controls. Having all those sliders in the loop gives you a lot of opportunity for oxidized contacts. With a program playing through it at a medium level try exercising each control (one at a time) through its range to see (hear) if it makes a positive difference. Do that for each slider. Unused physical controls tend to glom up in time.
Very bad hum one is 60hz second is a loud buss would like the sch
Hi.
I have a similar one of these, and am having some issues with it. I have previously repaired the power supply section which is on the back of the unit screwed to to the left of the I/O section (when looking from the front). The capacitors weren't too crash hot so I replaced them, though I am having an ongoing problem so was hoping you might be able to help me if you've learnt anything about the unit.
I'm getting a very low signal, ie: I can just hear the sound when the amp is maxed up. I noticed when I ran the system with the ground of the amp lead I got a good signal???
Anyway, cheers.
Robert.
[email protected]
Not finding what you are looking for?