Dewalt Logo

Dewalt Recent Questions, Troubleshooting Help & Support

  • 1K Products
  • 17K Answers
  • 548K Views

Its the compressor... not enough pressure.

Dewalt DC618KA... | Answered on Oct 14, 2019


Dewalt Jig Saw

DeWalt Jig Saw MANUAL ManualsOnline com


Blade catch wears out too fast
I loved this tool when it was working but after not that much use the teeth that hold the blade under pressure no longer hold hard enough to prevent the blade from coming out. The mechanism that holds the blade has no catch hole, it uses a few serated teeth to pressure hold the blade in place. Unfortunately, once the pressure starts to lessen you can't tighten it down...

Dewalt 331K 6.5... | Answered on Oct 09, 2019


Have you tried changing the AA Batteries, sounds simple, but a lot of people forget to try this. When they go flat, they lock the radio out and nothing will work. HHM Dewalt Agent

Dewalt DC011... | Answered on Oct 08, 2019


maybe so it works when not plugged in to an outlet

Dewalt Audio... | Answered on Oct 05, 2019


The nailer must be firmly pressed against the surface you are planning to nail. This will arm the nailer in preparation for firing the nail.

Dewalt Tools &... | Answered on Oct 03, 2019


if the plug on the cord fits any other outlet in the house it will be single phase
if the cord is cut , then it will have only 3 wires if it is single phase
( active , neutral and ground )
if it has 4 or more wires it will be 3 phase
most saws running a 200 mm blade or around that size and used for home duty will be single phase
the phase notation will be on the plate attached to the motor of the saw
It will read voltage , amperage, watts or hp, phase and cycles

Dewalt Saws | Answered on Oct 03, 2019


Not enough volume... if psi is good just increase the size of the line.

Dewalt Air Tools... | Answered on Oct 02, 2019


Educated guess that the adjustment screw (knob) is not locked OR the screw shaft is worn on the top/bottom allowing the gear to jump off the screw thread. Does it shake when the planner is off? A question is Is the thickness indicator still showing the original setting?
From another site: Once the height is set, remember to push the black bar back down to lock the cutting head in place.
DeWalt web site customer rep might be able to assist you.

Dewalt Planer... | Answered on Sep 26, 2019


if you are using thin cutting disk turn arbor nut over. It he shaft is rotating while tightening disc, use shaft lock button on side of gear box.
Page 10 of your instruction manual. Here is a link


DeWalt D28402 Instruction Manual Page 10

Dewalt Saws | Answered on Sep 11, 2019


OPEN CHUCK FULLY AND LOOK INSIDE , THERE IS A SC REW YOU NEED TO REMOVE USUALLY A LEFT HAND THREADED ONE

Dewalt Drills | Answered on Sep 06, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dewalt Experts

John Trevino

Level 3 Expert

1420 Answers

JOHN LAPIER

Level 3 Expert

2591 Answers

Brad Brown

Level 3 Expert

18108 Answers

Are you a Dewalt Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...