Danco Home - Recent Questions, Troubleshooting & Support
Danco Hot/Cold Stem installation instructions
Hi,
The spring goes in first then the rubber seat goes on top.put them
together first on a small screwdriver,insert on hole push down on rubber
into hole it should stay.replace stem in reverse order of taking off.
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
The Danco Universal Faucet replacement handle
Get some Lock-tight formula to apply to the screw. Let it dry a few minutes after application. Naturally, after application of the solution, you have tightened the screw to its maximum. Do not be concerned about ever removing the screw as the material will loosens when you apply manual force.
I have a rebuild kit
The issue might be the tub diverter spout. Most such do not seal well. It is a matter of jiggling the spout knob. It should seal better with a little experimenting.
9/4/2017 6:38:14 PM •
Danco Home
•
Answered
on Sep 04, 2017
I installed stem and the valve will not shut cold water off that is running
If your having major issues, I would try to locate the main on/off valves at your water heater and pump/cold water line in the basement. One the water is shut off, I would try to check if there is a proper seal...as required concerning the stem. It's probably on of the old gaskets that was not remove and doubled up. Happened to me. Good luck!
www.youtube.com/watch?v=kM-TxozD-b4
Not finding what you are looking for?