Danby Washing Machines - Popular Questions, Answers, Tips & Manuals

It does have a filter, but it is out of stock. https://www.reliableparts.ca/product/inv_11431896 Drop a gallon of bleach into it. Put it on hot wash, and before it pumps out, turn it off and leave it full for a couple of days full. Then carry on with the cycle. It should loosen all the debris. https://www.google.com/search?q=danby+model+dwm99w+filter ..

BEST SOLUTION IS CALL A LOCAL REPAIR SERVICE MY DISHWASHER HAS 2 ARMS AND LEGS

Most washers of my experience have at least one programme that stops the wash, leaving water in the tub until the programmer is advanced a notch by hand when it will pump out and enter the rinse/spin cycles. I suggest you reread the instructions just to be clear whether there is a fault.

check to see if 'closed lid switch' is working.

Maybe it’s a dual action agitator where top turns independently of the bottom. Gears inside agitator may be stripped out.

Since you are dealing with a gas appliance and any gas appliance could blow I strongly suggest contact your gas company and have them come out and help you with this.

Your load must be very unballanced

you have a new washer so why not get the service agents out under warranty to fix the faulty machine ask why there was water in a new machine as that indicates not new but second hand

Is the circuit breaker for the wall plug tripped?

If what you mean is that the water level rises too much, then what you have is a bad water level switch. You will spot it easy, for it has a hose attached to it. Sometimes they just jam and all it needs is a gentle tapping. But is likely that it will jam again

Off balance causes: What to Do if Washer Is Off Balance During the Spin Cycle With Every Load http://www.partselect.com/Repair/Washer/Shakes-Moves

With a wire hook.

Try to see eBay.com or Amazon.com. Try to call or visit the place u bought the washer from, they should b able to give u what ur looking for

use something to press or pull the lever that is left to open the door

you sure it isnt 12 volts

Look Here http://www.miniwasher.com/mini_washer_danby_dtt420w.htm Mini Washers at DISCOUNT prices compact clothes laundry washers

test the door switch and look for a blown fuse

sounds like the bearrings r gone

pump probly

Sounds like it make be the belt is broke, without this the wheel is unable to turn the drum. failing that it may be a sinister motor problem needing a rewind of motor which usually is not worth it... best of luck either way