Daewoo Washing Machines - Page 2 - Recent Questions, Troubleshooting & Support

the pipe you are using is too small for the amount of water you are forcing into it

what has Daewoo told you might be wrong with it

Use the washing machine manual or search it online. Unless we see what is happening we can't really help you.

DWF-200MS I have a DAEWOO DWF-200MS top loader washing machine and when I switch it on I get an error code E9. Can you please tell me the fault and how to repair it?

If the belt mechanism is either loose or slipped or that the belt is damaged or worn out it might not be able to spin with enough or spin at all then . If the belt is broken or fully off the rollers then it can't spin at all. A washer that won't spin is not washing. If it can not agitate clothes and then clothes don't get clean. Call a repair person to have a look at your washing machine to see what the issue is.

No Reset procedure mentioned anywhere https://www.manualslib.com/products/Daewoo-Dwd-1212-4405009.html Try cutting the power and reconnecting whilst holding the power button in. If that doesn't work, try holding the Power and Pause at the same time. Hold for about 10 seconds.

You can get in touch with RIYADH center for more details.. Dongbu Daewoo Electronics CORPORATION, RIYADH LIAISON OFFICE Rayes B/D Office No.8 Olaya St. B/D No. 30 Riyadh, Kingdom of Saudi Arabia Tel : 96-61-461-5350/4542 Fax : 96-61-461-5356 http://www.dongbudaewooelec.com/english/cscenter_01.asp

According to the service manual,

Daewoo Washing Machine Error Fault Code = LE
Fault Detected: Washing Machine Door Open
Washer Has Detected: Washing machine detected door as open or not locked
Check / Repair / Fix = Close door – Door lock switch – Door latch – PCB

Waar kan ek motor herstel of koop vir Daewoo air injection 9020 teen n bekostigbare prys

Message = E2 Error = OVERFLOW ERROR Cause & Solution = The water is supplied continuously due to an defective inlet valve. Change the valve inlet. The valve inlet is normal, but the water level sensor Change the water level sensor (sensor pressure) is low. (sensor pressure). The drain motor does not work - Test and if faulty change the drain pumpMessage = E9 Error = SENSOR PRESSURE ERROR Cause & Solution = The water level sensor is faulty. Change the water level sensor. (remove pressure tube and blow through it to make sure it is clear first)

remove it and check for anything that is jamming it if good u can make up a lead to test and see if it runs

there is an error no 9

my Daedwoo DWF-806 MP machine when i swith on shows figure 49 and not figure 0, and it also making noise like Buzz in between when the machine is ON. Can anybody help me to resolve this defect thanks

DAEWOO MACHINE IS NOT USED

if spin not worke there is 3 resone one spin motor out of order2. spin door not close well 3 capacitor is not good

it should snap back on press down on it

Most likely a control or motor issue. Probably should call service.