D-Link Recent Questions, Troubleshooting Help & Support

Sorry, no, the DI-634M does not have the repeating function.

Usually you can login on your browser to you router and go to the management section to check for firmware updates and select that button and it will download and install the firmware. On some models, you have to go to the D-link web site and look for firmware updates for your router. Always check what you current firmware you have installed and check the version of your router modem hardware (A, B, C etc). Then you can manually download the firmware (usually in a ZIP file), open the zip file, and then using your browser connected to the router look for Update Firmware. You will have to go to where (folder) you saved the downloaded update and select that file. It is recommended that you update using a LAN connection and not a wireless connection.

I have used Cat5e plenum Cable for my internet connection and I faced same problem. If you are just concerned with internet access and not access between devices on your LAN, then you just need to connect the first router LAN to the WAN port of the second router with the mentioned Ethernet cable. It is also in your best interest to make sure the IP ranges are different between the two DHCP servers you now have. That is, make sure they are not on the same subnet or serving up conflicting IP's.

you can reset your router, at the back you easily find very little button which indicates that is the reset button. press reset then you will be able to fix your new user name & password.

Thanks

is this adapter?? i think their is no fuse in wireless router.....If you need any kind of technical assistance you can contact support cell at http://www.vtechsquad.com/

If you can't remember the password, follow these directions to reset the access point to factory default. You can then log in with a username of admin and a blank password. DAP 1360 Wifi Access Point Hard Reset PCingredient If you know the current password, just log in and change it on this page http://www.support.dlink.com/emulators/dap1360/101/tools_admin.htm

i want chenge password

The nook is designed to attach to a PC (or AC) with The cable that came with the nook. IF your PC does not have a USB port, it cannot connect.

Username is "admin" Password is blank

go to an internet browser on a pc connected to router type in address url http://192.168.0.1 type admin for the user name leave password box empty click ok don't use wizard click on wireless button on screen select enable for wep select asci then type in a password key for the wep that you will remember click on apply bottom of screen page 12 - 14 https://fccid.io/KA2DI774VB1/Users-Manual/Users-Manual-1-357565.pdf

Contact D-link support number 1-888-494-1155 (Toll-free) usa and find instant help by expert D-link technicians.

put one of them in DMZ zone or use port triggering.

do you have a good internet connection?

factory reset

Do a reset back to factory defaults. Hold the button down in the pin hole for 30 secs.

How do I log into my D Link wireless router?

• Open up a Web browser.

• Type the address "http://192.168.0.1" or "http://dlinkrouter" (omit the quotes) into the browser's address bar, and then press "Enter."

• Log in to the D-Link router with the administrator username and password.
• The default username is Admin and the password is blank (nothing).

Noone supports Windows XP anymore. I wouldn't count on any driver updates.

Verify that your laptop can connect to the D-Link. Then on the laptop, in the search window enter CMD. In that window enter " ping 8.8.8.8" If you get a response - actually 5, then your likely issue on the D-Link is DHCP settings. Enter "close" to close the black CMD screen. A response proves that you have Internet access but only to numeric addresses. Use the supplied disk or instruction manual to log into the D-Link and update the settings. If you get no response, go through the full setup procedure on the D-Link.