D-Link Computers & Internet - Page 8 - Recent Questions, Troubleshooting & Support
Switch simply wont start up after power failure.
Maybe there was a power surge or spike that damaged the router. But if you unplug it and wait a minute or two, then plug it back in, maybe that will reset it. If it is a router, there's usually a small red button on the back, sometimes recessed, that will reset it and that might cure it.
2/19/2018 11:35:15 PM •
D-Link...
•
Answered
on Feb 19, 2018
WBR 2310 wireless stops working.
Please reset the router and also remove the network from the devices and reconnect with the password.
for more visit www.leadingpcfix.com
2/13/2018 2:15:08 PM •
D-Link...
•
Answered
on Feb 13, 2018
My dlink is restricting port 3389
YOU SHOULD FIRST HARD RESET THE MODEM USING A PAPER CLIP WHILE ITS POWERED ON AND RE CONFIGURE ALLOWING THE REMOTE ACCESS PORT TO WORK
Yesterday i bought a D-link
You should go to the dlink support web page to troubleshoot your problem. That message means that the link between your router and the internet is not working. Could be a physical or configuration issue.
Can't configure in repeater mode
Try turning off the WEP and connecting. Are you using repeater mode on your router, or just adding the repeater to your network?
DWR-113, forgotten password and now can't set up
You will have to do a manual factory reset of your router. Locate a small hole on the back of the unit and using the tip of a paper clip, insert it into the hole for about 10 seconds with the power on, and this will reset the router to its factory settings.
I keep getting the error
Hi,
Have you tried a different browser to login to the router?? Make sure you do not have any browser toolbars installed on the computer as they can often interfere with secure logins.
2/2/2018 6:35:13 PM •
D-Link...
•
Answered
on Feb 02, 2018
Not finding what you are looking for?