Crosley Washing Machines - Page 4 - Recent Questions, Troubleshooting & Support

(1) The tub bearing is mounted in the middle of the outer tub. The tub bearing helps to keep the inner tub spinning smoothly. Replacing the tub bearing is a very involved repair and will require disassembling most of the washer. If the tub bearing is defective, i recommend replacing both the outer tub and bearing.

IT is very difficult to explain all the procedure here by this window. If you wish to know more, visit the site linked here. Pull up older posts. http://homenol.blogspot.com/

could be Brake rotor and lining you can see if it is working by turning the belt by hand http://www.repairclinic.com/PartDetail/Crosley-Washing-Machine-Brake-Lining/WP356714/1480293?modelNumber=CW6000W&ss=a11b171d86950&mr=1

The drain hose might be too low. Make sure the drain hose is at least three feet above the floor.

If the above adjustment doesn't produce positive results, replace the control.

Soap powder or too much soap powder?

look at the back and there are 3 screws

I used to work with pc's and when in doubt I rebooted. Cable boxes, routers and even these fancy machines. Turn it off, unplug it from the wall wait about 30 seconds and plug it back in. I'm not sure if this will do the trick but I had a repair guy here for my old Maytag neptune and he wasn't sure either so I unplugged it and it reset itself. He learned something new that day. Hope this helps. If not someone else will come along and reply as well with another method.