Crosley Washing Machines - Page 3 - Recent Questions, Troubleshooting & Support

If your washer just keeps filling it and the pressure valve is not to blame I would suggest that your tube coming off of the pressure valve might be blocked or partially blocked. If you have hard water where you live try taking off that line (it just pulls off fairly easy) and squirt some CLR into the tube. A good way to check to see if there is any restriction is when you take off that tube. You should be able to blow though it very easily.

uplug power. remove switch, then tape the wires together. this will make a complete curcuit, so it should run. good-day !

This would be a control board issue, pull the panel apart and check for burned connector and circuit board overheating. If the control boards are showing signs of heat damage you may have a defective drive motor as well.

make sure that it didn't stop because of an unbalanced situation as it is draining it should be turning slowly and as soon as it empties the spin speed picks and and the unbalance stops the machine