Crosley Audio Players & Recorders - Page 8 - Recent Questions, Troubleshooting & Support

Make sure volume is turned up. Check internal fuse. Check speaker connections.

Type "Crosley CR47 user manual" into search engine and it will show sites for manuals. Check the trouble shooting section. If that doesn't help: check internal fuse, volume control, speakers and connrctions

Check and see if there is fuse. Use volt meter to check power input and if power output from transformer.

Go online.

what's the question?

You have to get a program for your computer to use with Crosley. Unfortunately, there is none.

Type Crosley Model # of your device user manual " into search engine and it will show sites to get manual. In it there might be a way to help you

Type Crosley CR249TA User Manual " into search engine and it will show sites to get manual. In manual there are instructions to help you.

The turn table is ANALOG and your PC is DIGITAL.

Type " Crosley Model # of device User Manual " into search engine and it will bring up sites to get manual. In manual check trouble shooting section.

If it is happening while playing, the needle if off balance and / or needs a new needle.

Type " Crosley the model # of your device user manual " in search engine and it will show sites to get manual. You can check the trouble shooting section.

Type " Crosley CR248 User Manual " in search engine and it will bring up sites to get manual. I'm pretty sure a wiring diagram is in user manual'

Type " Crosley CR248 User Manual " in your search engine and it will bring up sites to get manual.

Look thru the user's guide of codes to program new remote. Not all devices are listed in the guide. You can try other device's codes when programming, if you can't find the code designated for your device. I found emerson and symphonics use the same codes.

Type " Crosley CR248 user manual " into search engine and it will show sites to get manual. Some radios have 2 fuses in them. I could be blown. If you attempt to check the fuses... UNPLUG RADIO !!!!!!

what exactly is the problem? is the platter not spinning?

Could be it needs a new drive belt or wheel and examine the turntable bearings and spindle at the same time. If it is a synchronous motor providing the drive it could be ready for attention as such motors are prone to seized bearings. It would be wise also to ensure the tone arm moves freely and the stylus weight is correctly adjusted.