Craftsman Vacuums - Popular Questions, Answers, Tips & Manuals

There are no schematics because you aren't supposed to take them apart. You can sent it back or just buy a new one. https://www.manualslib.com/manual/1739428/Craftsman-Easy-Fire-0993056.html#manual ..

Check the ball is free in the centre of the head. Check the seal on the canister. Although yours is Craftsman, they all work the same. https://www.ridgidforum.com/forum/power-tools/power-tool-discussion-forum/40103-shop-vac-will-blow-but-won-t-suck https://www.google.com/search?q=16+gallon+Craftsman+shopvac+has+suddenly+stopped+vaccuuming+and+started+blowing ..

possibly you need to put in fresh gas if there was gas in it already when you got it drain old gas into a proper container and dispose of responsibly. https://www.searspartsdirect.com/partsdirect/user-manuals# the above link will take you to the sear's site, under "find the right manual for your product" enter your model number for access to a free download

I don't know exactly but if it has one it will usually be found in intimate contact with the motor. Some vacs were fitted with a bimetal breaker which is also sited close to the motor, but sometimes there is so much dust around once they open they fail to make a good contact again when the cool and close. Older vacs weren't fitted with any safety devices.

The price of motor is expensive. Perhaps you would be money ahead and buy a new vacuum at HD or Lowe's. 826404 Motor Assembly

Yes, you need to take it apart. Maybe ask a friend who knows Mechanics or Electrical.

Most wet dry vacs have a ball float that blocks the vacuum when it is full of liquid. Yours sounds as if it is full or the ball has gotten stuck in the up, or blocking position.

Your make and model number appears isn't stated and the category designation is incomplete. Find the model and look for a thermal protection fuse. https://www.searspartsdirect.com/combo/0247-1235880/craftsman-wet-dry-vacuum-parts ..

Absolutely yes. If not, the filter will be saturated with water and ruined.

Follow cord to where it goes on mower, then connect the wires the same way you took them off. but be sure to turn power off!!

Yes, but depending on vacuum some can be difficult

is it a Single motor ? photos would be helpful - of switch & motor/cap. wire conn.

blockage in the suction line if it is the wet mode there should be a valve (ball) that sucks up to stop water from getting to the motor when the receiver is too full. If you are in wet mode and still have the dust bag in place then the bag will be a solid block of mud and that will be the blockage.

First check if the bag is full. Then check if hose is clogged or attachment is clogged.

Check that water cut off is not sticking on.

Maybe it over heated or the hose was jammed. Unplug it for a few minutes, check the hose for any stuck debris, then plug it back in. Shop vacs also come with a filter. If the filter is too dirty, it might have shut off as a safety precaution to not cause a fire. Follow directions to clean the filter. Hope this helped. Dee

The foam just is put over the round center beneath the top of vacumn with top off the bucket. Just slide up to top of round assembly and you good to go. If you have the paper bag filter on remove it first.

If the check ball is stuck closing airway, the strike the unit on top when its off, you may hear the ball drop and there try again. Otherwise, if that's not it, most like the fan portion inside to create air movement has separated from shaft of motor assembly. You may try top open top and reconnect, but if you not sure don't try this. Take a look at product info for possible replacement or back to store for advice.

Craftsman 17765 canister vacuum cleaner is known for its assortment of power tools especially when it comes to cleaning jobs. It is designed to give you an easier, more effective cleaning. This vacuum cleaner delivers a high capacity reservoir, power and the versatility to swap easily between tasks. Craftsman wet/dry vaccums soaks even drosp of water on the floor with one of their 16 gallon wet/dry vacuum. It is also equipped with utility nozzle, extension wands, and dust bag that makes the cleaning process easier. The extension wands can clean the hard to reach areas like cupboards, corners, and bends. It has a large gallon tank that includes convenient drain port for easy emptying when the job is done.

Attachments

Number of Tools:

Attachment Type:

Brush

Details and Capabilities

Cord Length:

Tank / Bag Capacity:

12 Gallons

Weight:

Hose Reach:

Cleaning Areas:

Car

Electricity

Horsepower:

5 HP

Voltage:

110 - 120 V AC

Power Consumption:

1210 Watts

replace the switch went out