Craftsman Tools & Hardware - Others - Page 9 - Recent Questions, Troubleshooting & Support

usually there is a coupling to connect the 2 parts I would think that it has cracked. If you have the brand and model number get back to me and I will try and find the part number for you or you can go to their website and look it up.

the thermal overload or the fan has melted to the shroud .. jay

manualsonline.com

Hi jdenney274...
Your regulator is not working properly...replace it
Please take time to rate me

they show this as a planer, but to get a manual go to managemyhome.com and click on the manual icon and on the next page type in your model number. The manual I found was 20 pages long. If I have helped you would you please vote accordingly and thank you

Undo the chuck nut and then knock the spindle shaft of the sanding disc in lightly. This should release the collet's grip on the shaft. If the shaft has been pushed all the way into the chuck, remove the collets and nut and try separate the collet segments to release it from the shaft.

Hi, can you put the bit hard in so it can't work up and set the table deeper to suit? If not, drop a spacer of some sort in behind the bit. Hope this helps, regards Phil.

To make sure that you have everything assembled correctly it would be better if you downloaded the free manual from
http://www.hammerwall.com/Download_Manual/43956/
You may have to register, but this is a free service and well worth it.
Let me know if you have any problems or further questions. Thanks.
Please rate this solution.

You can order it on the link below.

http://www.craftsman.com/shc/s/p_10155_12602_00910995000P

On page 2 of the link below will tell you how to change the bit on the flex shaft.

http://www.managemylife.com/mmh/lis_pdf/OWNM/L0403078.pdf